Re: [PATCH v3 2/2] power: supply: bq25630: Initialize hardware before exposing the power supply

On Thu, Jul 30, 2026 at 09:17 +0800 Linmao Li <[email protected]> wrote:

> bq25630_setup() resets the device, disables the watchdog and programs
> the charge limits from the battery information. It runs at the end of
> bq25630_probe(), that is after the power supply has been registered, so
> the device is already exposed to the system while the hardware still
> holds its power-on defaults.
>
> power_supply_desc::init runs during registration, after the driver data
> and the fwnode are available and before the device is added. Use it for
> bq25630_setup() and drop the explicit call from bq25630_probe().
>
> The callback is passed the power supply, so take the driver data from it
> and use it for the battery information as well: data->psy is only
> assigned once devm_power_supply_register() returns, which is after the
> callback has run.
>
> Signed-off-by: Linmao Li <[email protected]>

You didn't include my "Reviewed-by" tag? Anyway, here it is again (there is no diff against previous version):

Reviewed-by: Waqar Hameed <[email protected]>