[PATCH 01/15] soc: qcom: geni-se: allow selection on 32-bit ARM Qualcomm SoCs
Hardeep Sharma <[email protected]>
| Newsgroups | org.kernel.vger.linux-pm,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-clk,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-gpio,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
Commit e10b198a94c6 ("soc: qcom: Restrict drivers per ARM/ARM64")
tightened QCOM_GENI_SE's dependency to ARM64 || COMPILE_TEST on the
assumption that no ARMv7 Qualcomm SoC uses the GENI Serial Engine
hardware.
Kuno, a 32-bit ARM Cortex-A7 Qualcomm SoC, uses the GENI-based QUP
wrapper for its debug UART, so this assumption no longer holds.
Fixes: e10b198a94c6 ("soc: qcom: Restrict drivers per ARM/ARM64")
Signed-off-by: Hardeep Sharma <[email protected]>
---
drivers/soc/qcom/Kconfig | 1 -
1 file changed, 1 deletion(-)
diff --git a/drivers/soc/qcom/Kconfig b/drivers/soc/qcom/Kconfig
index fd4d4ecd2df0..5b3c9d31fd7f 100644
--- a/drivers/soc/qcom/Kconfig
+++ b/drivers/soc/qcom/Kconfig
@@ -39,7 +39,6 @@ config QCOM_COMMAND_DB
config QCOM_GENI_SE
tristate "Qualcomm GENI Serial Engine Driver"
- depends on ARM64 || COMPILE_TEST
default ARCH_QCOM
help
This driver is used to manage Generic Interface (GENI) firmware based
--
2.43.0