Re: [PATCH 15/15] ARM: dts: qcom: Add initial device tree for Kuno SoC

On Tue, Aug 11, 2026 at 04:13:40AM +0300, Dmitry Baryshkov wrote:
> On Sun, Aug 09, 2026 at 12:57:14PM +0530, Hardeep Sharma wrote:
> > Add SoC-level DTSI (qcom-kuno.dtsi) and IDP board DTS
> > (qcom-kuno-idp.dts) for the Qualcomm Kuno SoC.
> > 
> > Peripherals included in this initial set:
> >   - Single Cortex-A7 CPU with PSCI idle states
> >   - RPMh RSC with clock controller, power domains, and BCM voter
> >   - GCC (Global Clock Controller)
> >   - TLMM pin controller (110 GPIOs)
> >   - Interconnect (aggre-noc, cnoc-main)
> >   - GENI UART console (QUP SE3)
> >   - SMEM, hardware spinlocks (TCSR mutex)
> 
> This is pretty limited without any storage. Does it NAND?

It has serial connection. this is enough for a start. At least one
communication interface is needed for early upstreaming.

Best regards,
Krzysztof