Re: [PATCH 5/7] spi: qcom-geni: Use geni_se_set_rate() for setting source clock frequency

On 8/5/2026 1:27 AM, Praveen Talari wrote:
> On the SA8255P platform there is no Linux clock handler for the SE
> source clock, so the driver has no way to look up the source clock
> index and divider needed to fill the GSI CONFIG0 TRE for a requested
> transfer frequency. To work around this, firmware instead exposes the
> SE HW supported source clock frequencies as OPPs on the perf domain
> device.
> 
> geni_se_domain_attach() now populates se->clk_perf_tbl from this OPP
> table at attach time, mirroring clk_perf_tbl on the Linux-clock-managed
> path. This lets get_spi_clk_cfg() call geni_se_clk_freq_match() to pick
> the closest supported source clock frequency and divider on SA8255P
> exactly as it already does when a Linux clock is present, and fill in
> the GSI CONFIG0 TRE accordingly.
> 
> Switch get_spi_clk_cfg() and spi_geni_runtime_resume() from calling
> dev_pm_opp_set_rate() directly to the new geni_se_set_rate() helper, so
> the matched frequency is applied to the correct device (the perf
> domain device on the firmware managed path, or se->dev otherwise)
> without the SPI driver needing to know which resources_init variant is
> in use.
> 

let me suggest little compressed commit message removing some duplication.

geni_se_domain_attach() now populates clk_perf_tbl from
the performance-domain OPP table, allowing firmware-managed
platforms to use geni_se_clk_freq_match().

Use geni_se_set_rate() instead of dev_pm_opp_set_rate()
so clock programming is handled centrally by the GENI core,
independent of the underlying clock-control mechanism.

> Signed-off-by: Praveen Talari <[email protected]>
> ---
>   drivers/spi/spi-geni-qcom.c | 17 ++++++-----------
>   1 file changed, 6 insertions(+), 11 deletions(-)
> 
> diff --git a/drivers/spi/spi-geni-qcom.c b/drivers/spi/spi-geni-qcom.c

[...]

> @@ -150,9 +148,9 @@ static int get_spi_clk_cfg(unsigned int speed_hz,
>   
>   	dev_dbg(mas->dev, "req %u=>%u sclk %lu, idx %d, div %d\n", speed_hz,
>   				actual_hz, sclk_freq, *clk_idx, *clk_div);
> -	ret = dev_pm_opp_set_rate(mas->dev, sclk_freq);
> +	ret = geni_se_set_rate(&mas->se, sclk_freq);
>   	if (ret)
> -		dev_err(mas->dev, "dev_pm_opp_set_rate failed %d\n", ret);
> +		dev_err(mas->dev, "geni_se_set_rate failed %d\n", ret);
little verbose - "Failed to set source clock rate %d">   	else
>   		mas->cur_sclk_hz = sclk_freq;
>   
> @@ -847,7 +845,7 @@ static int setup_se_xfer(struct spi_transfer *xfer,
>   	}

[...]