[PATCH v5 3/3] arm64: dts: qcom: add SoCCP DT node for Glymur
Ananthu C V <[email protected]>
| Newsgroups | org.kernel.vger.linux-remoteproc,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
From: Sibi Sankar <[email protected]> The SoC Control Processor (SoCCP) is a small RISC-V MCU that controls USB Type-C, battery charging, and various other functions on Qualcomm SoCs. Add the nodes required to enable SoCCP on Glymur/Mahua SoCs. Signed-off-by: Sibi Sankar <[email protected]> Co-developed-by: Ananthu C V <[email protected]> Signed-off-by: Ananthu C V <[email protected]> --- arch/arm64/boot/dts/qcom/glymur-crd.dtsi | 7 +++++ arch/arm64/boot/dts/qcom/glymur.dtsi | 44 ++++++++++++++++++++++++++++++++ 2 files changed, 51 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/glymur-crd.dtsi b/arch/arm64/boot/dts/qcom/glymur-crd.dtsi index e784b538f42e..328eb513140f 100644 --- a/arch/arm64/boot/dts/qcom/glymur-crd.dtsi +++ b/arch/arm64/boot/dts/qcom/glymur-crd.dtsi @@ -585,6 +585,13 @@ &remoteproc_cdsp { status = "okay"; }; +&remoteproc_soccp { + firmware-name = "qcom/glymur/soccp.mbn", + "qcom/glymur/soccp_dtb.mbn"; + + status = "okay"; +}; + &tlmm { gpio-reserved-ranges = <4 4>, /* EC TZ Secure I3C */ <10 2>, /* OOB UART */ diff --git a/arch/arm64/boot/dts/qcom/glymur.dtsi b/arch/arm64/boot/dts/qcom/glymur.dtsi index 9ec7c256b80a..e3dee05de3a3 100644 --- a/arch/arm64/boot/dts/qcom/glymur.dtsi +++ b/arch/arm64/boot/dts/qcom/glymur.dtsi @@ -2297,6 +2297,50 @@ &config_noc SLAVE_QUP_0 QCOM_ICC_TAG_ALWAYS>, }; }; + remoteproc_soccp: remoteproc@d00000 { + compatible = "qcom,glymur-soccp-pas", "qcom,kaanapali-soccp-pas"; + reg = <0x0 0x00d00000 0x0 0x200000>; + + interrupts-extended = <&intc GIC_SPI 167 IRQ_TYPE_EDGE_RISING>, + <&soccp_smp2p_in 0 IRQ_TYPE_EDGE_RISING>, + <&soccp_smp2p_in 1 IRQ_TYPE_EDGE_RISING>, + <&soccp_smp2p_in 2 IRQ_TYPE_EDGE_RISING>, + <&soccp_smp2p_in 3 IRQ_TYPE_EDGE_RISING>, + <&soccp_smp2p_in 9 IRQ_TYPE_EDGE_RISING>; + interrupt-names = "wdog", + "fatal", + "ready", + "handover", + "stop-ack", + "pong"; + + clocks = <&rpmhcc RPMH_CXO_CLK>; + clock-names = "xo"; + + power-domains = <&rpmhpd RPMHPD_CX>, + <&rpmhpd RPMHPD_MX>; + power-domain-names = "cx", + "mx"; + + memory-region = <&soccp_mem>, + <&soccpdtb_mem>; + + qcom,smem-states = <&soccp_smp2p_out 0>, + <&soccp_smp2p_out 8>; + qcom,smem-state-names = "stop", + "ping"; + + glink-edge { + interrupts-extended = <&ipcc IPCC_MPROC_SOCCP + IPCC_MPROC_SIGNAL_GLINK_QMP + IRQ_TYPE_EDGE_RISING>; + mboxes = <&ipcc IPCC_MPROC_SOCCP + IPCC_MPROC_SIGNAL_GLINK_QMP>; + qcom,remote-pid = <19>; + label = "soccp"; + }; + }; + usb_hs_phy: phy@fa0000 { compatible = "qcom,glymur-m31-eusb2-phy", "qcom,sm8750-m31-eusb2-phy"; -- 2.43.0