[PATCH] dt-bindings: arm: qcom,coresight-tpdm: fix bracket
Manuel Ebner <[email protected]>
| Newsgroups | org.kernel.vger.linux-renesas-soc,org.kernel.vger.linux-clk,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
Add ')' and fix sentence structure. Signed-off-by: Manuel Ebner <[email protected]> --- .../bindings/clock/renesas,rcar-usb2-clock-sel.yaml | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/clock/renesas,rcar-usb2-clock-sel.yaml b/Documentation/devicetree/bindings/clock/renesas,rcar-usb2-clock-sel.yaml index c84f29f1810f..a14be249fa33 100644 --- a/Documentation/devicetree/bindings/clock/renesas,rcar-usb2-clock-sel.yaml +++ b/Documentation/devicetree/bindings/clock/renesas,rcar-usb2-clock-sel.yaml @@ -13,8 +13,8 @@ description: | If you connect an external clock to the USB_EXTAL pin only, you should set the clock rate to "usb_extal" node only. If you connect an oscillator to both the USB_XTAL and USB_EXTAL, this module - is not needed because this is default setting. (Of course, you can set the - clock rates to both "usb_extal" and "usb_xtal" nodes. + is not needed because this is default setting (Of course, you can set the + clock rates to both "usb_extal" and "usb_xtal" nodes). Case 1: An external clock connects to R-Car SoC +----------+ +--- R-Car ---------------------+ -- 2.54.0