RE: [PATCH] irqchip/renesas-rzg2l: Fix loss of interrupt

Hi All,

> -----Original Message-----
> From: Biju <[email protected]>
> Sent: 13 August 2026 17:48


> Subject: [PATCH] irqchip/renesas-rzg2l: Fix loss of interrupt
> 
> From: Biju Das <[email protected]>
> 
> Read modify write on rzg2l_clear_{tint,irq}_int() is causing loss of interrupts when multiple interrupts
> are triggered, for example with:
> 
>   gpioset -c gpiochip0 355=0 353=0 328=0 352=0
> 
> The ISCR/TSCR status registers are write-1-to-clear per bit, so any bit written as 0 is left unchanged by

Typo here. Write 0 to clear the status bit and any bit written as 1 is ignored.

Hardware manual mentions 1 as "Invalid to write". According to the hardware engineer,

"Invalid to write" means that the write operation is invalid. Even if a '1' is written to the target bit of the TSCR/ISCR, the write is ignored, and the interrupt status remains unchanged.( so, it is "No effect".)

> hardware. The current code reads the register, clears only the handled bit in software, and writes back
> the whole value. If another interrupt's status bit gets set between the read and the write, that set bit
> is written back as 1, clearing an interrupt that hasn't been serviced yet, so it gets lost.
             back as 0

> 
> Fix this by writing back only the bit being cleared (all other bits as 0) instead of read-modify-writing

                                                      (all other bits as 1)

I will update the commit description in the next version.

Cheers,
Biju

> the whole register, so that concurrently-set status bits for other interrupts are left intact.
> 
> Fixes: 3fed09559cd8 ("irqchip: Add RZ/G2L IA55 Interrupt Controller driver")
> Signed-off-by: Biju Das <[email protected]>
> ---
>  drivers/irqchip/irq-renesas-rzg2l.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/irqchip/irq-renesas-rzg2l.c b/drivers/irqchip/irq-renesas-rzg2l.c
> index f6b2e69a2f4e..b3774f82855a 100644
> --- a/drivers/irqchip/irq-renesas-rzg2l.c
> +++ b/drivers/irqchip/irq-renesas-rzg2l.c
> @@ -161,7 +161,7 @@ static void rzg2l_clear_irq_int(struct rzg2l_irqc_priv *priv, unsigned int hwirq
>  	 * falling/rising-edge.
>  	 */
>  	if ((iscr & bit) && (iitsr & IITSR_IITSEL_MASK(hw_irq))) {
> -		writel_relaxed(iscr & ~bit, priv->base + ISCR);
> +		writel_relaxed(~bit, priv->base + ISCR);
>  		/*
>  		 * Enforce that the posted write is flushed to prevent that the
>  		 * just handled interrupt is raised again.
> @@ -177,7 +177,7 @@ static void rzg2l_clear_tint_int(struct rzg2l_irqc_priv *priv, unsigned int hwir
> 
>  	reg = readl_relaxed(priv->base + TSCR);
>  	if (reg & bit) {
> -		writel_relaxed(reg & ~bit, priv->base + TSCR);
> +		writel_relaxed(~bit, priv->base + TSCR);
>  		/*
>  		 * Enforce that the posted write is flushed to prevent that the
>  		 * just handled interrupt is raised again.
> --
> 2.43.0
>