[PATCH v3 5/7] PCI: rzg3s-host: Move suspend/resume code into dedicated functions
Claudiu Beznea <[email protected]>
| Newsgroups | org.kernel.vger.linux-renesas-soc,org.kernel.vger.linux-kernel,org.kernel.vger.linux-pci |
|---|---|
| Message-ID | <[email protected]> |
From: Claudiu Beznea <[email protected]> In preparation for implementing hotplug using pci_host_bridge::reset_root_port(), move the suspend/resume code into rzg3s_pcie_host_stop() and rzg3s_pcie_host_start(). These functions will later be reused by the hotplug implementation through pci_host_bridge::reset_root_port(). Signed-off-by: Claudiu Beznea <[email protected]> --- Changes in v3: - none, this patch is new drivers/pci/controller/pcie-rzg3s-host.c | 237 ++++++++++++----------- 1 file changed, 124 insertions(+), 113 deletions(-) diff --git a/drivers/pci/controller/pcie-rzg3s-host.c b/drivers/pci/controller/pcie-rzg3s-host.c index 579386d1aaa3..834b03d56713 100644 --- a/drivers/pci/controller/pcie-rzg3s-host.c +++ b/drivers/pci/controller/pcie-rzg3s-host.c @@ -1742,6 +1742,128 @@ rzg3s_pcie_host_setup(struct rzg3s_pcie_host *host, return ret; } +static int rzg3s_pcie_host_stop(struct rzg3s_pcie_host *host) +{ + const struct rzg3s_pcie_soc_data *data = host->data; + struct rzg3s_pcie_port *port = &host->port; + struct rzg3s_sysc *sysc = host->sysc; + int ret; + + clk_disable_unprepare(port->refclk); + + /* SoC-specific de-initialization */ + ret = data->config_deinit(host); + if (ret) + goto refclk_restore; + + ret = reset_control_bulk_assert(data->num_power_resets, + host->power_resets); + if (ret) + goto config_reinit; + + /* + * Since: + * - the runtime PM usage count was incremented by + * pm_runtime_get_noresume() in the system suspend/resume code before + * executing the subsystem-level .prepare() callback + * (in device_prepare()), + * - runtime PM has been disabled by the system suspend/resume code + * before executing the subsystem-level .suspend_late() callback + * (in device_suspend_late()), and + * - the PCIe driver's runtime PM state remains RPM_ACTIVE (it was + * runtime resumed in probe()), + * + * any runtime PM operation becomes a no-op and may lead to unexpected + * failures. + * + * Let the power domain's genpd_suspend_noirq() callback disable the + * clocks, as it already does. + */ + + ret = rzg3s_sysc_config_func(sysc, RZG3S_SYSC_FUNC_ID_RST_RSM_B, 0); + if (ret) + goto power_resets_restore; + + return 0; + + /* Restore the previous state if any error happens */ +power_resets_restore: + reset_control_bulk_deassert(data->num_power_resets, + host->power_resets); +config_reinit: + if (data->config_pre_init) + data->config_pre_init(host); + data->config_post_init(host); +refclk_restore: + clk_prepare_enable(port->refclk); + return ret; +} + +static int rzg3s_pcie_host_start(struct rzg3s_pcie_host *host) +{ + const struct rzg3s_pcie_soc_data *data = host->data; + struct rzg3s_sysc *sysc = host->sysc; + int ret; + + ret = rzg3s_sysc_config_func(sysc, RZG3S_SYSC_FUNC_ID_MODE, 1); + if (ret) + return ret; + + ret = rzg3s_sysc_config_func(sysc, RZG3S_SYSC_FUNC_ID_RST_RSM_B, 1); + if (ret) + return ret; + + if (host->num_lanes) { + ret = rzg3s_sysc_config_func(host->sysc, + RZG3S_SYSC_FUNC_ID_LINK_MASTER, + host->num_lanes == 2 ? + RZG3S_SYSC_LINK_MODE_DUAL_X2 : + RZG3S_SYSC_LINK_MODE_SINGLE_X4); + if (ret) + goto assert_rst_rsm_b; + } + + /* + * Since: + * - the runtime PM usage count was incremented by + * pm_runtime_get_noresume() in the system suspend/resume code before + * executing the subsystem-level .prepare() callback + * (in device_prepare()), + * - runtime PM has been disabled by the system suspend/resume code + * before executing the subsystem-level .suspend_late() callback + * (in device_suspend_late()), + * - on resume pm_runtime_enable() is called after executing the + * subsystem-level .resume_early() (in device_resume_early()) + * + * any runtime PM operation becomes a no-op and may lead to unexpected + * failures. + * + * Let the power domain's genpd_resume_noirq() callback enable the + * clocks, as it already does. + */ + + ret = rzg3s_pcie_power_resets_deassert(host); + if (ret) + goto assert_rst_rsm_b; + + ret = rzg3s_pcie_host_setup(host, rzg3s_pcie_msi_hw_setup, + rzg3s_pcie_msi_hw_teardown); + if (ret) + goto assert_power_resets; + + return 0; + + /* + * If any error happens there is no way to recover the IP. Put it in the + * lowest possible power state. + */ +assert_power_resets: + reset_control_bulk_assert(data->num_power_resets, host->power_resets); +assert_rst_rsm_b: + rzg3s_sysc_config_func(sysc, RZG3S_SYSC_FUNC_ID_RST_RSM_B, 0); + return ret; +} + static int rzg3s_pcie_get_controller_id(struct rzg3s_pcie_host *host) { struct device_node *np = host->dev->of_node; @@ -1939,126 +2061,15 @@ static int rzg3s_pcie_probe(struct platform_device *pdev) static int rzg3s_pcie_suspend_noirq(struct device *dev) { struct rzg3s_pcie_host *host = dev_get_drvdata(dev); - const struct rzg3s_pcie_soc_data *data = host->data; - struct rzg3s_pcie_port *port = &host->port; - struct rzg3s_sysc *sysc = host->sysc; - int ret; - - clk_disable_unprepare(port->refclk); - - /* SoC-specific de-initialization */ - ret = data->config_deinit(host); - if (ret) - goto refclk_restore; - - ret = reset_control_bulk_assert(data->num_power_resets, - host->power_resets); - if (ret) - goto config_reinit; - - /* - * Since: - * - the runtime PM usage count was incremented by - * pm_runtime_get_noresume() in the system suspend/resume code before - * executing the subsystem-level .prepare() callback - * (in device_prepare()), - * - runtime PM has been disabled by the system suspend/resume code - * before executing the subsystem-level .suspend_late() callback - * (in device_suspend_late()), and - * - the PCIe driver's runtime PM state remains RPM_ACTIVE (it was - * runtime resumed in probe()), - * - * any runtime PM operation becomes a no-op and may lead to unexpected - * failures. - * - * Let the power domain's genpd_suspend_noirq() callback disable the - * clocks, as it already does. - */ - - ret = rzg3s_sysc_config_func(sysc, RZG3S_SYSC_FUNC_ID_RST_RSM_B, 0); - if (ret) - goto power_resets_restore; - - return 0; - /* Restore the previous state if any error happens */ -power_resets_restore: - reset_control_bulk_deassert(data->num_power_resets, - host->power_resets); -config_reinit: - if (data->config_pre_init) - data->config_pre_init(host); - data->config_post_init(host); -refclk_restore: - clk_prepare_enable(port->refclk); - return ret; + return rzg3s_pcie_host_stop(host); } static int rzg3s_pcie_resume_noirq(struct device *dev) { struct rzg3s_pcie_host *host = dev_get_drvdata(dev); - const struct rzg3s_pcie_soc_data *data = host->data; - struct rzg3s_sysc *sysc = host->sysc; - int ret; - ret = rzg3s_sysc_config_func(sysc, RZG3S_SYSC_FUNC_ID_MODE, 1); - if (ret) - return ret; - - ret = rzg3s_sysc_config_func(sysc, RZG3S_SYSC_FUNC_ID_RST_RSM_B, 1); - if (ret) - return ret; - - if (host->num_lanes) { - ret = rzg3s_sysc_config_func(host->sysc, - RZG3S_SYSC_FUNC_ID_LINK_MASTER, - host->num_lanes == 2 ? - RZG3S_SYSC_LINK_MODE_DUAL_X2 : - RZG3S_SYSC_LINK_MODE_SINGLE_X4); - if (ret) - goto assert_rst_rsm_b; - } - - /* - * Since: - * - the runtime PM usage count was incremented by - * pm_runtime_get_noresume() in the system suspend/resume code before - * executing the subsystem-level .prepare() callback - * (in device_prepare()), - * - runtime PM has been disabled by the system suspend/resume code - * before executing the subsystem-level .suspend_late() callback - * (in device_suspend_late()), - * - on resume pm_runtime_enable() is called after executing the - * subsystem-level .resume_early() (in device_resume_early()) - * - * any runtime PM operation becomes a no-op and may lead to unexpected - * failures. - * - * Let the power domain's genpd_resume_noirq() callback enable the - * clocks, as it already does. - */ - - ret = rzg3s_pcie_power_resets_deassert(host); - if (ret) - goto assert_rst_rsm_b; - - ret = rzg3s_pcie_host_setup(host, rzg3s_pcie_msi_hw_setup, - rzg3s_pcie_msi_hw_teardown); - if (ret) - goto assert_power_resets; - - return 0; - - /* - * If any error happens there is no way to recover the IP. Put it in the - * lowest possible power state. - */ -assert_power_resets: - reset_control_bulk_assert(data->num_power_resets, - host->power_resets); -assert_rst_rsm_b: - rzg3s_sysc_config_func(sysc, RZG3S_SYSC_FUNC_ID_RST_RSM_B, 0); - return ret; + return rzg3s_pcie_host_start(host); } static const struct dev_pm_ops rzg3s_pcie_pm_ops = { -- 2.43.0