Re: [PATCH] x86: mshyperv: Use kthread for vmbus interrupts on PREEMPT_RT

On 04.02.26 08:19, Jan Kiszka wrote:
> On 04.02.26 08:00, Wei Liu wrote:
>> On Tue, Feb 03, 2026 at 05:01:30PM +0100, Jan Kiszka wrote:
>>> From: Jan Kiszka <[email protected]>
>>>
>>> Resolves the following lockdep report when booting PREEMPT_RT on Hyper-V
>>> with related guest support enabled:
>>
>> So all it takes to reproduce this is to enabled PREEMPT_RT?
>>
> 
> ...and enable CONFIG_PROVE_LOCKING so that you do not have to wait for
> your system to actually run into the bug. Lockdep already triggers
> during bootup.
> 
>> Asking because ...
>>
>>>  	struct pt_regs *old_regs = set_irq_regs(regs);
>>> @@ -158,8 +196,12 @@ DEFINE_IDTENTRY_SYSVEC(sysvec_hyperv_callback)
>>>  	if (mshv_handler)
>>>  		mshv_handler();
>>
>> ... to err on the safe side we should probably do the same for
>> mshv_handler as well.
>>
> 
> Valid question. We so far worked based on lockdep reports, and the
> mshv_handler didn't trigger yet. Either it is not run in our setup, or
> it is actually already fine. But I have a code review on my agenda
> regarding potential remaining issues in mshv.
> 
> Is there something needed to trigger the mshv_handler so that we can
> test it?
> 

Ah, that depends on CONFIG_MSHV_ROOT. Is that related to the accelerator
mode that Magnus presented in [1]? We briefly chatted about it and also
my problems with the drivers after his talk on Saturday.

Jan

[1]
https://fosdem.org/2026/schedule/event/BFQ8XA-introducing-mshv-accelerator-in-qemu/

-- 
Siemens AG, Foundational Technologies
Linux Expert Center