[PATCH v2 08/10] clk: bd718x7: Support ROHM BD73800

From: Matti Vaittinen <[email protected]>

The ROHM BD73800 PMIC has a 32.768 kHz clock gate. Add support for
controlling this clock.

NOTE: The CLKOUT pin can be muxed by an OTP option. On some OTP
configurations the CLKOUT is not outputting the clk signal.

Signed-off-by: Matti Vaittinen <[email protected]>

---
Revision history:
 v1 => :
  - No changes
---
 drivers/clk/clk-bd718x7.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/clk/clk-bd718x7.c b/drivers/clk/clk-bd718x7.c
index 1cae974e6d1d..2dc6b8e46f18 100644
--- a/drivers/clk/clk-bd718x7.c
+++ b/drivers/clk/clk-bd718x7.c
@@ -21,6 +21,9 @@
 #define BD718XX_REG_OUT32K	0x2E
 /* BD72720 */
 #define BD72720_REG_OUT32K	0x9a
+/* BD73800 */
+#define BD73800_REG_OUT32K	0x50
+
 /*
  * BD71837, BD71847, and BD71828 all use bit [0] to clk output control
  */
@@ -123,6 +126,10 @@ static int bd71837_clk_probe(struct platform_device *pdev)
 		c->reg = BD72720_REG_OUT32K;
 		c->mask = CLK_OUT_EN_MASK;
 		break;
+	case ROHM_CHIP_TYPE_BD73800:
+		c->reg = BD73800_REG_OUT32K;
+		c->mask = CLK_OUT_EN_MASK;
+		break;
 	default:
 		dev_err(&pdev->dev, "Unknown clk chip\n");
 		return -EINVAL;
@@ -152,6 +159,7 @@ static const struct platform_device_id bd718x7_clk_id[] = {
 	{ "bd71828-clk", ROHM_CHIP_TYPE_BD71828 },
 	{ "bd71815-clk", ROHM_CHIP_TYPE_BD71815 },
 	{ "bd72720-clk", ROHM_CHIP_TYPE_BD72720 },
+	{ "bd73800-clk", ROHM_CHIP_TYPE_BD73800 },
 	{ },
 };
 MODULE_DEVICE_TABLE(platform, bd718x7_clk_id);
-- 
2.55.0

-----BEGIN PGP SIGNATURE-----

iQEzBAEBCgAdFiEEIx+f8wZb28fLKEhTeFA3/03aocUFAmpxvYUACgkQeFA3/03a
ocUt6gf/Z79R2a0inH6wCI69ywBpui212rNJBnVRMBPexlrZi758a4NDQgk0YjRI
IybHp+0domj40zb8yyizEyPzlYoLejbNPC7e+XSrxW/ut/qNYPeBGsd8S8vWrpg7
4/s8mx/vce2bWuqNXWs8l9xBBBuDGO9trX3eMAkYfghp3X8XNBaS3YIzFX2Nz5Dx
ZNJHqfsjW6IaLVNXROQXWcVesWjrvRhfSt7UtArkK5T/eTZpamdLQt5P4VODuAtH
4FhCbzxAw3zsl+yyiIGeXzQKpBxP+8KTs8KvKqLEK+vYLNxkgp3ue5ZT9Aifi93Z
4Ip7EGAb/MjdvOF8e7uf54ImyzQVtA==
=as9c
-----END PGP SIGNATURE-----