[RESEND v7 1/2] dt-bindings: rtc: Add pcf85053 support

Add device tree bindings for NXP PCF85053 RTC chip.

Signed-off-by: Pankit Garg <[email protected]>
Signed-off-by: Lakshay Piplani <[email protected]>
Reviewed-by: Conor Dooley <[email protected]>
---
V6 -> V7: - no changes
	  - Added Reviewed-by: Conor Dooley <[email protected]>
V5 -> V6: - Dropped driver-specific commentary from property descriptions.
	  - Simplified and clarified descriptions for better readability.
V4 -> V5: - Updated schema validation logic to enforce correct combinations of
            'nxp,interface' and 'nxp,write-access' using oneOf clauses.
          - Refined property descriptions for clarity and hardware alignment.
V3 -> V4: Add dedicated nxp,pcf85053.yaml.
          Remove entry from trivial-rtc.yaml.
V2 -> V3: Moved MAINTAINERS file changes to the driver patch
V1 -> V2: Handled dt-bindings by trivial-rtc.yaml

 .../devicetree/bindings/rtc/nxp,pcf85053.yaml | 114 ++++++++++++++++++
 1 file changed, 114 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/rtc/nxp,pcf85053.yaml

diff --git a/Documentation/devicetree/bindings/rtc/nxp,pcf85053.yaml b/Documentation/devicetree/bindings/rtc/nxp,pcf85053.yaml
new file mode 100644
index 000000000000..81cfceabc04c
--- /dev/null
+++ b/Documentation/devicetree/bindings/rtc/nxp,pcf85053.yaml
@@ -0,0 +1,114 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+# Copyright 2025 NXP
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/rtc/nxp,pcf85053.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: NXP PCF85053 Real Time Clock
+
+maintainers:
+  - Pankit Garg <[email protected]>
+  - Lakshay Piplani <[email protected]>
+
+properties:
+  compatible:
+    enum:
+      - nxp,pcf85053
+
+  reg:
+    maxItems: 1
+
+  interrupts:
+    maxItems: 1
+
+  nxp,interface:
+    $ref: /schemas/types.yaml#/definitions/string
+    enum: [ primary, secondary ]
+    description: |
+      Identifies this host's logical role in a multi-host topology for the
+      PCF85053 RTC. The device exposes a "TWO" ownership bit in the CTRL
+      register that gates which host may write time/alarm registers.
+        - "primary": Designated host that *may* claim write ownership (set
+          CTRL.TWO=1) **if** write-access is explicitly requested.
+        - "secondary": Peer host that writes only when CTRL.TWO=0 (default).
+
+      This property determines the intended role of the host in relation to
+      the write ownership.
+
+      The actual role depends on whether 'nxp,write-access' is also specified.
+      Supported configurations are:-
+        1. Primary with 'nxp,write-access' -> primary claims write ownership.
+        2. Primary without 'nxp,write-access' -> primary is ready only; secondary may write.
+        3. Secondary (must not specify 'nxp,write-access') -> Secondary writes only
+           when no primary claims ownership.
+
+  nxp,write-access:
+    type: boolean
+    description: |
+      Indicates that write ownership of the PCF85053 RTC should be claimed by setting
+      CTRL.TWO=1. This property is only valid when acting as the primary interface
+      (nxp,interface="primary").
+
+required:
+  - compatible
+  - reg
+  - nxp,interface
+
+additionalProperties: false
+
+allOf:
+  - $ref: rtc.yaml#
+  - if:
+      properties:
+        nxp,interface:
+          const: secondary
+    then:
+      not:
+        required: [ "nxp,write-access" ]
+
+examples:
+  # Single host example.
+  - |
+    #include <dt-bindings/interrupt-controller/irq.h>
+    i2c {
+      #address-cells = <1>;
+      #size-cells = <0>;
+
+      rtc@6f {
+        compatible = "nxp,pcf85053";
+        reg = <0x6f>;
+        nxp,interface = "primary";
+        nxp,write-access;
+        interrupt-parent = <&gpio2>;
+        interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
+      };
+    };
+
+  # Dual-host example: one primary that claims writes; one secondary that never claims writes.
+  - |
+    #include <dt-bindings/interrupt-controller/irq.h>
+    i2c0 {
+      #address-cells = <1>;
+      #size-cells = <0>;
+
+      rtc@6f {
+        compatible = "nxp,pcf85053";
+        reg = <0x6f>;
+        nxp,interface = "primary";
+        nxp,write-access;
+        interrupt-parent = <&gpio2>;
+        interrupts = <3 IRQ_TYPE_EDGE_FALLING>;
+      };
+    };
+
+    i2c1 {
+      #address-cells = <1>;
+      #size-cells = <0>;
+
+      rtc@6f {
+        compatible = "nxp,pcf85053";
+        reg = <0x6f>;
+        nxp,interface = "secondary";
+      };
+    };
-- 
2.25.1