Re: [PATCH v5 04/17] rtc: rzn1: Handle unset alarm weekday in rzn1_rtc_read_alarm
"Lad, Prabhakar" <[email protected]>
| Newsgroups | org.kernel.vger.linux-rtc,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel,org.kernel.vger.linux-renesas-soc,org.kernel.vger.stable |
|---|---|
| Message-ID | <CA+V-a8tAUirxWKyCx9yvYgp0EkysxgkgK20-RArzFFKOXuHSvg@mail.gmail.com> |
Hi Wolfram, THank you for the review. On Fri, Aug 21, 2026 at 4:08 PM Wolfram Sang <[email protected]> wrote: > > On Fri, Aug 21, 2026 at 02:55:55PM +0100, Prabhakar wrote: > > From: Lad Prabhakar <[email protected]> > > > > RZN1_RTC_ALW is a weekday bitmask where bit N represents weekday N. > > When no alarm has been configured, the register has its power-on-reset > > value of zero. > > > > rzn1_rtc_read_alarm() uses fls() to convert the weekday bitmask into a > > weekday number. When RZN1_RTC_ALW is zero, fls(0) returns zero and > > fls(wday) - 1 evaluates to -1. This invalid weekday is then used to > > calculate the alarm date and can either leave tm_wday set to -1 or > > produce a fabricated alarm date. > > > > Treat a zero RZN1_RTC_ALW value as an unset alarm weekday and return > > without calculating the alarm date. Move reading RZN1_RTC_CTL1 before > > this check so that alrm->enabled is updated for both configured and > > unconfigured alarms. > > > > On a cold-booted board with no alarm configured, the following was > > observed before the fix: > > > > root@rzn2h-evk:~# cat /proc/driver/rtc > > rtc_time : 00:00:19 > > rtc_date : 2000-01-01 > > alrm_time : 00:00:00 > > alrm_date : 2000-01-07 > > alarm_IRQ : no > > alrm_pending : no > > update IRQ enabled : no > > periodic IRQ enabled : no > > periodic IRQ frequency : 1 > > max user IRQ frequency : 64 > > 24hr : yes > > > > After the fix: > > > > root@rzn2h-evk:~# cat /proc/driver/rtc > > rtc_time : 00:00:25 > > rtc_date : 2000-01-01 > > alrm_time : 00:00:00 > > alrm_date : 2000-01-01 > > alarm_IRQ : no > > alrm_pending : no > > update IRQ enabled : no > > periodic IRQ enabled : no > > periodic IRQ frequency : 1 > > max user IRQ frequency : 64 > > 24hr : yes > > The output of the tests could be dropped IMO, but I'll leave this for > the RTC maintainers. > I'll drop it. Cheers, Prabhakar > > Fixes: b5ad1bf00d2c4 ("rtc: rzn1: Add alarm support") > > Cc: [email protected] > > Signed-off-by: Lad Prabhakar <[email protected]> > > Other than that: > > Reviewed-by: Wolfram Sang <[email protected]> > Tested-by: Wolfram Sang <[email protected]> >