Re: [PATCH 4/7] serial: qcom-geni: Use geni_se_set_rate() for source clock configuration
Mukesh Savaliya <[email protected]>
| Newsgroups | org.kernel.vger.linux-serial,org.infradead.lists.linux-arm-kernel,org.kernel.vger.arm-scmi,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-i2c,org.kernel.vger.linux-kernel,org.kernel.vger.linux-pm,org.kernel.vger.linux-spi |
|---|---|
| Message-ID | <[email protected]> |
On 8/5/2026 1:27 AM, Praveen Talari wrote: > @@ -1474,7 +1473,10 @@ static int geni_serial_set_rate(struct geni_se *se, unsigned long baud) > > uport->uartclk = clk_rate; > port->clk_rate = clk_rate; > - dev_pm_opp_set_rate(uport->dev, clk_rate); > + ret = geni_se_set_rate(&port->se, clk_rate); > + if (ret) Can you add trace log with an error for geni serial driver ?> + return ret; > + > ser_clk_cfg = SER_CLK_EN; > ser_clk_cfg |= clk_div << CLK_DIV_SHFT; > > @@ -1513,7 +1515,7 @@ static void qcom_geni_serial_set_termios(struct uart_port *uport, [...]