[PATCH 2/2] spi: cadence-quadspi: release DMA channel on probe failure

When spi_register_controller() fails in cqspi_probe(), the DMA channel
acquired via cqspi_request_mmap_dma() is not released, leaking the channel.
Add a dedicated error label to release the DMA channel before the
existing runtime PM teardown path.

This fix is one part of upstream commit f18c8cfa4f1a ("spi: cadence-qspi:
Fix probe error path and remove").

Fixes: b85815675fc5 ("spi: cadence-quadspi: fix cleanup of rx_chan on failure paths")
Cc: [email protected]
Signed-off-by: Diogo Ivo (Schneider Electric) <[email protected]>
---
 drivers/spi/spi-cadence-quadspi.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c
index d749dee54015..66304664a1cf 100644
--- a/drivers/spi/spi-cadence-quadspi.c
+++ b/drivers/spi/spi-cadence-quadspi.c
@@ -1982,14 +1982,17 @@ static int cqspi_probe(struct platform_device *pdev)
 	ret = spi_register_controller(host);
 	if (ret) {
 		dev_err(&pdev->dev, "failed to register SPI ctlr %d\n", ret);
-		goto disable_rpm;
+		goto release_dma_chan;
 	}
 
 	pm_runtime_mark_last_busy(dev);
 	pm_runtime_put_autosuspend(dev);
 
 	return 0;
-disable_rpm:
+release_dma_chan:
+	if (cqspi->rx_chan)
+		dma_release_channel(cqspi->rx_chan);
+
 	pm_runtime_put_noidle(dev);
 	pm_runtime_dont_use_autosuspend(dev);
 	pm_runtime_disable(dev);

-- 
2.55.0