[PATCH v3 2/2] spi: ma35d1-qspi: Enable GPIO chip selects

Chi-Wen Weng <[email protected]> Mon, 3 Aug 2026 15:49:13 +0800
Newsgroups org.kernel.vger.linux-spi,org.infradead.lists.linux-arm-kernel,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel
Message-ID <[email protected]>
From: Chi-Wen Weng <[email protected]>

The generic SPI controller binding allows GPIO-based chip selects, but
the MA35D1 QSPI driver does not currently enable the SPI core's GPIO
descriptor handling.

Enable GPIO chip-select support and distinguish the total number of chip
selects from the controller's two native chip selects. Allow num-cs to
include additional GPIO chip selects and set max_native_cs to the native
hardware limit.

Add a setup callback that rejects chip-select indices beyond the native
limit when no GPIO descriptor is present. Also reject active-high
polarity only for native chip selects, while allowing GPIO chip-select
polarity to be handled by the GPIO subsystem.

Signed-off-by: Chi-Wen Weng <[email protected]>
---
 drivers/spi/spi-ma35d1-qspi.c | 32 ++++++++++++++++++++++++++++----
 1 file changed, 28 insertions(+), 4 deletions(-)

diff --git a/drivers/spi/spi-ma35d1-qspi.c b/drivers/spi/spi-ma35d1-qspi.c
index 541d5d72484c..f893a4160528 100644
--- a/drivers/spi/spi-ma35d1-qspi.c
+++ b/drivers/spi/spi-ma35d1-qspi.c
@@ -61,7 +61,7 @@
 #define NUVOTON_QSPI_STATUS_RXEMPTY_MASK	BIT(8) /* Receive FIFO Empty */
 #define NUVOTON_QSPI_STATUS_BUSY_MASK	BIT(0) /* Busy Status */
 
-#define NUVOTON_QSPI_MAX_NUM_CS		2
+#define NUVOTON_QSPI_MAX_NATIVE_CS	2
 #define NUVOTON_QSPI_DEFAULT_NUM_CS	2
 #define NUVOTON_QSPI_DEFAULT_BPW	8
 /* Bound PIO operations to avoid long atomic polling loops. */
@@ -430,13 +430,34 @@ static void nuvoton_qspi_set_cs_level(struct nuvoton_qspi *qspi,
 	spin_unlock_irqrestore(&qspi->ssctl_lock, flags);
 }
 
+static int nuvoton_qspi_setup(struct spi_device *spi)
+{
+	unsigned int cs = spi_get_chipselect(spi, 0);
+
+	if (spi_get_csgpiod(spi, 0))
+		return 0;
+
+	if (cs >= NUVOTON_QSPI_MAX_NATIVE_CS) {
+		dev_err(&spi->dev, "invalid native chip select %u\n", cs);
+		return -EINVAL;
+	}
+
+	if (spi->mode & SPI_CS_HIGH) {
+		dev_err(&spi->dev,
+			"active-high native chip select is not supported\n");
+		return -EINVAL;
+	}
+
+	return 0;
+}
+
 static void nuvoton_qspi_set_cs(struct spi_device *spi, bool level)
 {
 	struct nuvoton_qspi *qspi = spi_controller_get_devdata(spi->controller);
 
 	/*
-	 * The SPI core passes the physical CS level to ->set_cs(). This
-	 * initial driver only supports active-low native chip selects.
+	 * The SPI core passes the physical CS level to ->set_cs(). Native
+	 * chip selects are active low.
 	 */
 	nuvoton_qspi_set_cs_level(qspi, spi_get_chipselect(spi, 0), !level);
 }
@@ -608,15 +629,18 @@ static int nuvoton_qspi_probe(struct platform_device *pdev)
 	if (ret && ret != -EINVAL)
 		return dev_err_probe(dev, ret, "failed to read num-cs\n");
 
-	if (!num_cs || num_cs > NUVOTON_QSPI_MAX_NUM_CS)
+	if (!num_cs)
 		return dev_err_probe(dev, -EINVAL, "invalid num-cs %u\n",
 				     num_cs);
 
 	ctlr->num_chipselect = num_cs;
+	ctlr->max_native_cs = NUVOTON_QSPI_MAX_NATIVE_CS;
+	ctlr->use_gpio_descriptors = true;
 	ctlr->max_transfer_size = nuvoton_qspi_max_transfer_size;
 	ctlr->max_message_size = nuvoton_qspi_max_message_size;
 	ctlr->mem_ops = &nuvoton_qspi_mem_ops;
 	ctlr->mem_caps = &nuvoton_qspi_mem_caps;
+	ctlr->setup = nuvoton_qspi_setup;
 	ctlr->set_cs = nuvoton_qspi_set_cs;
 	ctlr->transfer_one = nuvoton_qspi_transfer_one;
 	ctlr->bits_per_word_mask = SPI_BPW_MASK(8);
-- 
2.25.1