Re: [PATCH v2 0/3] Add quad mode support for QPIC SNAND

On Fri, 07 Aug 2026 21:33:54 +0530, Md Sadre Alam wrote:
> Add quad mode support for QPIC SNAND
> 
> The Qualcomm QPIC SPI-NAND controller supports both single (x1) and
> quad (x4) transfer modes, however the current driver operates only in
> single-bit mode. This series adds support for quad data transfers and
> includes a vendor-specific fix required for Macronix SPI-NAND devices.
> 
> [...]

Applied to

   https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git for-7.3

Thanks!

[1/3] spi: spi-qpic-snand: move command mapping helper
      https://git.kernel.org/broonie/spi/c/0d51ff742b41
[2/3] spi: spi-qpic-snand: add quad mode support
      https://git.kernel.org/broonie/spi/c/cdb1dbba4902
[3/3] spi: spi-qpic-snand: Handle Macronix quad read opcode 0x6b
      https://git.kernel.org/broonie/spi/c/7e3ffa9f46b7

All being well this means that it will be integrated into the linux-next
tree (usually sometime in the next 24 hours) and sent to Linus during
the next merge window (or sooner if it is a bug fix), however if
problems are discovered then the patch may be dropped or reverted.

You may get further e-mails resulting from automated or manual testing
and review of the tree, please engage with people reporting problems and
send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they
should be sent as incremental updates against current git, existing
patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying
to this mail.

Thanks,
Mark