Re: [PATCH v3 1/6] dt-bindings: iio: adc: ad7768-1: Document multidevice support

On 18/08/2026 01:32, Jonathan Santos wrote:
> The AD7768-1 family supports aggregating up to four devices on a single
> SPI controller, with each device occupying a dedicated CS line and a
> single data lane.
> 
> Extend the `reg` property to accept up to 4 entries (one per device).
> 
> Add `spi-rx-bus-width` property to declare the per-device lane count.
> Since each lane is bound to one CS, the number of entries must match
> `reg`. Make it required when `reg` has more than one entry.
> 
> Add an example for a four ADAQ7768-1 aggregation, with shared DRDY and
> SYNC_IN pin.
> 
> Signed-off-by: Jonathan Santos <[email protected]>
> ---
> Changes in v3:
> * New patch.

Please use scripts/get_maintainers.pl to get a list of necessary people
and lists to CC. It might happen, that command when run on an older
kernel, gives you outdated entries. Therefore please be sure you base
your patches on recent Linux kernel.

Tools like b4 or scripts/get_maintainer.pl provide you proper list of
people, so fix your workflow. Tools might also fail if you work on some
ancient tree (don't, instead use mainline) or work on fork of kernel
(don't, instead use mainline). Just use b4 and everything should be
fine, although remember about `b4 prep --auto-to-cc` if you added new
patches to the patchset.

You missed at least devicetree list (maybe more), so this won't be
tested by automated tooling. Performing review on untested code might be
a waste of time.

Please kindly resend and include all necessary To/Cc entries.

Best regards,
Krzysztof