[PATCH v14 18/38] phy: rockchip: usbdp: Rename mode_change to phy_needs_reinit

Right now the mode_change property is set whenever the mode changes
between USB-only, DP-only and USB-DP. It is needed, because on any
mode change the PHY needs to be re-initialized. Apparently at least
DP also requires a re-init when the cable orientation is changed,
which is currently not being done (except when the orientation switch
also involves a mode change). Prepare for this by renaming mode_change
to phy_needs_reinit.

Tested-by: Igor Paunovic <[email protected]> # Orange Pi 5 Plus
Signed-off-by: Sebastian Reichel <[email protected]>
---
 drivers/phy/rockchip/phy-rockchip-usbdp.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/phy/rockchip/phy-rockchip-usbdp.c b/drivers/phy/rockchip/phy-rockchip-usbdp.c
index 24108816e3b9..e44d19c9d119 100644
--- a/drivers/phy/rockchip/phy-rockchip-usbdp.c
+++ b/drivers/phy/rockchip/phy-rockchip-usbdp.c
@@ -171,7 +171,7 @@ struct rk_udphy {
 
 	/* PHY status management */
 	bool flip;
-	bool mode_change;
+	bool phy_needs_reinit;
 	u8 mode;
 	u8 status;
 
@@ -578,7 +578,7 @@ static void rk_udphy_mode_set(struct rk_udphy *udphy, u8 mode)
 	if (udphy->mode == mode)
 		return;
 
-	udphy->mode_change = true;
+	udphy->phy_needs_reinit = true;
 	udphy->mode = mode;
 }
 
@@ -951,15 +951,15 @@ static int rk_udphy_power_on(struct rk_udphy *udphy, u8 mode)
 
 		if (udphy->mode & UDPHY_MODE_USB)
 			rk_udphy_u3_port_disable(udphy, false);
-		udphy->mode_change = false;
-	} else if (udphy->mode_change) {
+		udphy->phy_needs_reinit = false;
+	} else if (udphy->phy_needs_reinit) {
 		if (udphy->mode == UDPHY_MODE_DP)
 			rk_udphy_u3_port_disable(udphy, true);
 
 		ret = rk_udphy_init(udphy);
 		if (ret)
 			return ret;
-		udphy->mode_change = false;
+		udphy->phy_needs_reinit = false;
 	}
 
 	udphy->status |= mode;

-- 
2.53.0