Re: [PATCH v5] wifi: brcmfmac: cyw: pass PMKID to firmware if present
Arend van Spriel <[email protected]>
| Newsgroups | org.kernel.vger.linux-wireless,dev.linux.lists.brcm80211,org.kernel.vger.linux-kernel,org.kernel.vger.stable |
|---|---|
| Message-ID | <[email protected]> |
On 07/08/2026 05:22, Bogdan Nicolae wrote:
> Zero out auth_status on initialization. Otherwise, garbage will
> leak from the stack to the firmware (when ssid is less than 32 bytes
> and/or when params->pmkid is set). Then, pass the params->pmkid to the
> firmware (without it, the firmware caches a garbage PMKID on successful
> authentication and denies a subsequent association request that includes
> the PMKID).
>
> Fixes: 66f909308a7c ("wifi: brcmfmac: cyw: support external SAE authentication in station mode")
> Signed-off-by: Bogdan Nicolae <[email protected]>
> Acked-by: Arend van Spriel <[email protected]>
It looks good, but in patchwork it showed the patch could not be applied
so I tried myself:
$ patch -p1 <
~/Downloads/v5-wifi-brcmfmac-cyw-pass-PMKID-to-firmware-if-present.diff
patching file drivers/net/wireless/broadcom/brcm80211/brcmfmac/cyw/core.c
/usr/bin/patch: **** malformed patch at line 23: bphy_err(drvr,
"External authentication failed: status=%d\n",
Been staring at it and not seeing the problem. Also checkpatch is not
complaining. Look at the hexdump and the last line was missing a space
before the tabs, but that was not the issue. The plot thickens...
> ---
> v5: Fixed line length > 80 chars
> v4: Fixed indentation
> v3: Added Fixes, Cc: stable, and Acked-by tags
Contrary to this there is no CC: stable tag in this patch.
> v2: Split into a separate patch
>
> drivers/net/wireless/broadcom/brcm80211/brcmfmac/cyw/core.c | 4 +++-
> 1 file changed, 3 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cyw/core.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cyw/core.c
> index 873754be5..2c59b5e57 100644
> --- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cyw/core.c
> +++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cyw/core.c
> @@ -200,7 +200,7 @@ brcmf_cyw_external_auth(struct wiphy *wiphy, struct net_device *dev,
> {
> struct brcmf_if *ifp;
> struct brcmf_pub *drvr;
> - struct brcmf_auth_req_status_le auth_status;
> + struct brcmf_auth_req_status_le auth_status = {};
> int ret = 0;
>
> brcmf_dbg(TRACE, "Enter\n");
> @@ -208,6 +208,8 @@ brcmf_cyw_external_auth(struct wiphy *wiphy, struct net_device *dev,
It looks like you hand edited the patch but now the number of line is 9
and not 8. Not sure if Johannes wants to hand edit that, but it does
apply once fixed.
Let's wait for Johannes to reply.
Regards,
Arend
> ifp = netdev_priv(dev);
> drvr = ifp->drvr;
> if (params->status == WLAN_STATUS_SUCCESS) {
> + if (params->pmkid)
> + memcpy(auth_status.pmkid, params->pmkid,
> + WLAN_PMKID_LEN);
> auth_status.flags = cpu_to_le16(BRCMF_EXTAUTH_SUCCESS);
> } else {
> bphy_err(drvr, "External authentication failed: status=%d\n",
> --
> 2.55.0