RE: [PATCH v3 0/5] wifi: rtw88: preparations for RTL8723B/RTL8723BS
Ping-Ke Shih <[email protected]>
| Newsgroups | org.kernel.vger.linux-wireless,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
Luka Gejak <[email protected]> wroet: > On August 4, 2026 8:54:20 AM GMT+02:00, [email protected] wrote: > >From: Luka Gejak <[email protected]> > > > >This is the first of two series adding support for the Realtek RTL8723B > >802.11n chipset and its RTL8723BS SDIO variant to rtw88. It contains > >only the changes to the shared rtw88 core that the chip driver depends > >on. The chip itself, the build glue and the MAINTAINERS entry are a > >second series. > > > >v1 had 19 patches, v2 had 11, this has 5. > > > > ... > > Hi Ping-Ke, > > I have sent a v4 that supersedes this series, before you review v3, so > you do not spend time on this one. As you suggested, I am noting it here > on the v3 cover. Thanks for the notification, and sorry for the late. I hope I can review v4 this Friday if no urgent tasks interrupt me. > > v4 re-adds two patches that were dropped in v2, both on the TX report and > leave-LPS paths. Testing on slower ARM SDIO hosts, Peter Robinson on the > RFC and another tester on a Rockchip RK3288 board, reproduced "failed to > get tx report from firmware" This makes sense for slower platform. > and "firmware failed to leave lps state", Does this only occur on "slow" platform? Unless a C2H event was handled slowly? I'll review the patch and add comment there. Ping-Ke