RE: [PATCH v7 0/6] wifi: rtw88: preparations for RTL8723B/RTL8723BS

On August 25, 2026 9:08:02 AM GMT+02:00, Ping-Ke Shih <[email protected]> wrote:

> Is this distribution of polling times?
> Does it mean 4 instances over 4 times of polling?

My fault for not explaining it. pollN counts wakes that finished on the Nth
read of REG_TCR, so poll1 needed one 20 ms sleep. fails counts the ones
still set after all five. So poll4=0 with fails=4 means nothing ever
succeeded on the last poll, yet four gave up completely. A budget that was
merely too small should taper instead. The patch also keeps polling for
another 500 ms and the bit was still set in all four.

> One reason the firmware can't leave LPS properly is that some packets
> are still in hardware queue, so this might be highly related to
> environment.

That fits better than anything I had, since it explains why it is either
quick or never. I will dump the queue lengths, REG_SDIO_FREE_TXPG and
REG_SDIO_OQT_FREE_PG at the failure and report back.

> More, it is worth to try disable_lps_deep=y.

Already off here, twice over: rtw8723b_hw_spec has
.lps_deep_mode_supported = 0 like rtw8723d and rtw8703b, and this firmware
reports no feature bits, so rtw_update_lps_deep_mode() returns
LPS_DEEP_MODE_NONE either way.

Best regards,
Luka Gejak