Re: [lm-sensors] [PATCH 0/2] hwmon: adc128d818: Support operation mode 1

On Tue, Mar 29, 2016 at 09:03:37PM +0200, Alexander Koch wrote:
> The ADC128D818 offers four different chip operation modes which vary in the
> number and measurement types of the available input signals (see datasheet
> sec. 8.4.1).
> 
> The current version of the driver only supports the default chip operation mode
> (mode 0), providing seven analog values and a temperature reading.
> 
> This patch series adds support for operation mode 1 (eight analog inputs but no
> temperature), selectable through the device tree attribute 'mode':
> 
>         adc1: adc128d818@1d {
>                 compatible = "ti,adc128d818";
>                 reg = <0x1d>;
>                 mode = /bits/ 8 <1>;
>         };
> 
> The changes are transparent as 'mode' defaults to mode 0 which yields the
> previous behaviour. Code has been tested on real hardware using an evaluation
> board.
> 
> Alexander Koch (2):
>   hwmon: adc128d818: Implement chip mode selection
>   hwmon: adc128d818: Implement operation mode 1
> 
>  drivers/hwmon/adc128d818.c | 113 +++++++++++++++++++++++++++++++++++++--------
>  1 file changed, 95 insertions(+), 18 deletions(-)
> 

Please send follow-up patches to [email protected].

Thanks,
Guenter

_______________________________________________
lm-sensors mailing list
[email protected]
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors