RE: [PATCH v3 net-next] ethtool: link 10000baseCR to SFF-8431, Appendix-E SFP+ DA

Copy-pasting & replying-all since selective reply doesn't seem to be helping.

No, Kuba. "v2 of ethtool" application patch was accepted and applied.
I received an explicit email for this acceptance & I see same on patchworks.

"v2 of net-next" kernel patch fell out and this "v3 net-next" was in response
to your repost request: https://lore.kernel.org/netdev/SN7PR11MB6900461F46AFCB0B170B9C829AC22@SN7PR11MB6900.namprd11.prod.outlook.com/

If you follow the below link, it gives the patch set summary:
https://patchwork.kernel.org/project/netdevbpf/list/?series=&submitter=Siddaraju&state=*&q=&archive=&delegate=

Am I missing something?

- Thank you,
Siddaraju D H

-----Original Message-----
From: Jakub Kicinski <[email protected]> 
Sent: Tuesday, July 28, 2026 6:42 AM
To: D H, Siddaraju <[email protected]>
Cc: Michal Kubecek <[email protected]>; Andrew Lunn <[email protected]>; Maxime Chevallier <[email protected]>; [email protected]; Das, Shubham <[email protected]>; Chintalapalle, Balaji <[email protected]>; Srinivasan, Vijay <[email protected]>; Lindberg, Magnus <[email protected]>; Niklas Damberg <[email protected]>; Wirandi, Jonas <[email protected]>; Siddaraju DH <[email protected]>
Subject: Re: [PATCH v3 net-next] ethtool: link 10000baseCR to SFF-8431, Appendix-E SFP+ DA

On Tue, 21 Jul 2026 20:36:38 +0530 Siddaraju DH wrote:
> Add comment to clarify the physical media 10000baseCR follows.
> 
> 10000baseCR does not correspond to any IEEE 802.3 *base-CR PMD.
> It has no autonegotiation, no link training, and no mandatory FEC.
> The industry standard for this media type is SFF-8431 Appendix-E
> Direct Attach cable, also known as 10G_SFI_DA.

v2 as already applied (no need to repost just for review tags)