Re: [PATCH net-next v4 0/3] w5100: restore GPIO-based link detection

On 11/08/2026 15:01, Arnd Bergmann wrote:
> On Tue, Aug 11, 2026, at 14:34, Arthur Crépin Leblond wrote:
>>
>> In the previous version of the w5100 driver, the LINKLED pin could be
>> wired to a GPIO to detect the link status changes via an interrupt.
>> This only works on w5500 as it is the only one documenting its LINKLED
>> pin to hold the link status (on w5100 the LINKLED pin is changing with
>> RX/TX activity).
>>
>> This series of patches is bringing back the link status detection on
>> w5500 using the Link Status bit of the PHY Configuration Register.
>> Additionally, the LINKLED pin can also be wired to detect link status
>> changes and read the register in the interrupt handler.
>>
>> Arthur Crépin Leblond
>>
>> Signed-off-by: Arthur Crépin Leblond <[email protected]>
>> ---
>> Changes in v4:
>> - Use directly an interrupt line instead of gpio -> irq
>> - Update interrupts in DT bindings
>> - Address sashiko reviews
>>  - drop devm_ on request_threaded_irq to avoid use after free
>>  - disable/enable the link_irq in the suspend/resume
>>  - only call netif_carrier_on|off if the link interrupt is present
>> - Link to v3: 
>> https://patch.msgid.link/[email protected]
> 
> Hi Arthur,
> 
> This version looks good to me,
> 
> Reviewed-by: Arnd Bergmann <[email protected]>
> 
> Krzystof said that he preferred these to be described as GPIOs
> instead, but I think there were some other open questions with
> your previous version. If you can come up with a version that
> Krzystof likes better, I'm fine with that as well.

No, interrupts are fine.

Best regards,
Krzysztof