Re: [PATCH net] net: do not bond/team netdevices which use ml_priv

Hi Oliver,
On Thu, Aug 20, 2026 at 01:06:18PM +0200, Oliver Hartkopp wrote:
> Hi Alexandra,
> > > How would bonding modify dev->ml_priv?
> > 
> > Could you give more information about this?
> > I hope there is no issue for qeth_l2. There we use and rely on dev->ml_priv.
> > 
> 
> I did some more investigation on all this.
> 
> There are 5 drivers that are using ml_priv:
> 
> - qeth
> - ctcm
> - cxgb2
> - i596
> - wilc1000
> 
> where qeth and i596 are using it to store a single pointer which can also be
> done by adding this pointer to their netdev_priv structure.
> 
> wilc1000 assigns ml_priv and never reads from it (development leftover).
> 
> Only cxgb2 and ctcm use it in a more complex way that would make it tricky
> to move its functionality into netdev_priv without having real hardware on
> the desk.
> 
> Either team and bonding do not fiddle with ml_priv on their own. But they
> make assumptions that best fit to ethernet devices where they don't care
> about nor copy any ml_priv pointers.
> 
> This caused a problem on CAN devices that were not created by the CAN driver
> infrastructure (creating proper ml_priv content). When TUN/TAP set the
> dev->type of an ethernet device to ARPHRD_CAN the CAN ml_priv is NULL (not
> initialized).

I don't know why a user change the tun/tap dev->type to CAN. Can they work
together? If it's a miss config, I think we can just leave it since we already
block CAN slave.

> 
> Long story short:
> 
> The ml_priv assignment in wilc100 can be removed.
> For ethernet devices like the qeth there's no problem AFAICS.
> But I would think about making use of netdev_priv() there:

[...]

> 
> The final question (which is not really a ml_priv issue) is how to tell
> team/bonding which netdevices are not capable to be used by them. To cover
> e.g. your ctcm driver using ARPHRD_SLIP.
> 
> The current check (bond_dev->type != slave_dev->type) would allow to join
> two type-identical interfaces, which was at least not a good idea for CAN.
> For that reason we already check (slave_dev->type == ARPHRD_CAN) there.
> Other dev->types might follow.
> 
> Not sure if collecting a bunch of ARPHRD values is the right approach or
> whether team/bonding should check required features and settings (like IFF
> flags, e.g. IFF_ARP or specific address length)?

Bond supports none arp devices. It also supports infiniband devices. So we
can't check it with IFF_ARP or address length.

From my perspective, we can keep the existing check as it only causes issues
with CAN devices. We can work out a better solution if more incompatible
devices are found under bond/team.

Thanks
Hangbin