[PATCH 1/2] net: phy: air_en8811h: move LED GPIO configuration to config_init

The LED GPIO pins (GPIO3/4/5, mapped to LED2/LED1/LED0) are only ever
configured as outputs once, in .probe(). But .config_init() restarts
the MD32 MCU via en8811h_restart_mcu() on every call after the first
(priv->mcu_needs_restart), and that restart resets buckpbus-mapped MCU
state, including EN8811H_GPIO_OUTPUT. As a result the LED GPIOs fall
back to inputs after the first event that re-triggers .config_init()
(link renegotiation, ifdown/ifup, resume), and the PHY's LEDs stop
reflecting link/activity state even though they worked right after
probe.

Move the GPIO-as-output configuration from .probe() to the end of
.config_init(), so it is reapplied every time the MCU may have been
restarted.

Fixes: 71e79430117d ("net: phy: air_en8811h: Add the Airoha EN8811H PHY driver")
Suggested-by: Mikhail Zhilkin <[email protected]>
Signed-off-by: Vitaliy Sochnev <[email protected]>
---
 drivers/net/phy/air_en8811h.c | 18 +++++++++++-------
 1 file changed, 11 insertions(+), 7 deletions(-)

diff --git a/drivers/net/phy/air_en8811h.c b/drivers/net/phy/air_en8811h.c
index edd49c193e47..0eeb7b9a4e26 100644
--- a/drivers/net/phy/air_en8811h.c
+++ b/drivers/net/phy/air_en8811h.c
@@ -1173,13 +1173,6 @@ static int en8811h_probe(struct phy_device *phydev)
 	if (ret)
 		return ret;
 
-	/* Configure led gpio pins as output */
-	ret = air_phy_buckpbus_reg_modify(phydev, EN8811H_GPIO_OUTPUT,
-					  EN8811H_GPIO_OUTPUT_345,
-					  EN8811H_GPIO_OUTPUT_345);
-	if (ret < 0)
-		return ret;
-
 	return 0;
 }
 
@@ -1324,6 +1317,17 @@ static int en8811h_config_init(struct phy_device *phydev)
 		return ret;
 	}
 
+	/* Configure led gpio pins as output. Must be redone on every
+	 * .config_init(), not just once in .probe(): en8811h_restart_mcu()
+	 * resets buckpbus-mapped MCU state (incl. this register) on every
+	 * call after the first, e.g. on link renegotiation or ifup/ifdown.
+	 */
+	ret = air_phy_buckpbus_reg_modify(phydev, EN8811H_GPIO_OUTPUT,
+					  EN8811H_GPIO_OUTPUT_345,
+					  EN8811H_GPIO_OUTPUT_345);
+	if (ret < 0)
+		return ret;
+
 	return 0;
 }
 
-- 
2.55.0