Re: [PATCH v7 5/8] media: qcom: camss: csiphy-3ph: Add Gen2 v1.1 MIPI CSI-2 C-PHY init

On 08/06/2026 11:00, Bryan O'Donoghue wrote:
> On 05/06/2026 14:14, David Heidelberg via B4 Relay wrote:
>>       case CAMSS_845:
>>           if (c->phy_cfg == V4L2_MBUS_CSI2_CPHY) {
>> -            regs->lane_regs = NULL;
>> -            regs->lane_array_size = 0;
>> +            regs->lane_regs = &lane_regs_sdm845_3ph[0];
>> +            regs->lane_array_size = ARRAY_SIZE(lane_regs_sdm845_3ph);
>>           } else {
>>               regs->lane_regs = &lane_regs_sdm845[0];
>>               regs->lane_array_size = ARRAY_SIZE(lane_regs_sdm845);
>>           }
> 
> The nittiest nit pick I can make sorry ...
> 
> IMO the default in the code should be DPHY with CPHY the alternative.

Sounds good, thou, the original lane regs, due to being only D-PHY available at 
that time, were uncoditional on V4L2_MBUS_CSI2_DPHY (which I assume has to be 
set anyway).

I was aiming to keep the original logic (thus else { ... D-PHY }).

Then I would do
if (DPHY)
elseif (CPHY)

if that's desired.
My pref would be another switch statement, but yo dawg, I heard you have switch 
statement inside the switch statement.... :)

David

> 
> Globally that should be true in this code.
> 
> ---
> bod

-- 
David Heidelberg