[PATCH v8 9/9] media: qcom: camss: Enable C-PHY where available
David Heidelberg via B4 Relay <[email protected]>
| Newsgroups | org.kernel.vger.phone-devel,org.kernel.feeds.b4-sent,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-kernel,org.kernel.vger.linux-media |
|---|---|
| Message-ID | <[email protected]> |
From: David Heidelberg <[email protected]> After all the changes done we can now safely enable C-PHY for a SoC where it's available. Acked-by: Cory Keitz <[email protected]> Reviewed-by: Bryan O'Donoghue <[email protected]> Reviewed-by: Frank Li <[email protected]> Signed-off-by: David Heidelberg <[email protected]> --- drivers/media/platform/qcom/camss/camss.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/drivers/media/platform/qcom/camss/camss.c b/drivers/media/platform/qcom/camss/camss.c index 66171069057f8..ebf8f21b5fa2e 100644 --- a/drivers/media/platform/qcom/camss/camss.c +++ b/drivers/media/platform/qcom/camss/camss.c @@ -4760,21 +4760,21 @@ static int camss_parse_endpoint_node(struct device *dev, struct v4l2_fwnode_endpoint vep = { { 0 } }; unsigned int i; int ret; ret = v4l2_fwnode_endpoint_parse(ep, &vep); if (ret) return ret; - /* - * Most SoCs support both D-PHY and C-PHY standards, but currently only - * D-PHY is supported in the driver. - */ - if (vep.bus_type != V4L2_MBUS_CSI2_DPHY) { + switch (vep.bus_type) { + case V4L2_MBUS_CSI2_CPHY: + case V4L2_MBUS_CSI2_DPHY: + break; + default: dev_err(dev, "Unsupported bus type %d\n", vep.bus_type); return -EINVAL; } csd->interface.csiphy_id = vep.base.port; mipi_csi2 = &vep.bus.mipi_csi2; lncfg->num_data = mipi_csi2->num_data_lanes; -- 2.53.0