[PATCH v2 3/3] arm64: dts: qcom: qcs6490-rb3gen2-vision-mezzanine: Use common pinctrl

Since there's already a define for gpio67 (mclk3) in kodiak.dtsi, use
that instead of defining an extra pinctrl state. Also rename the suspend
state to match naming.

No functional change intended.

Signed-off-by: Luca Weiss <[email protected]>
---
 .../boot/dts/qcom/qcs6490-rb3gen2-vision-mezzanine.dtso     | 13 +++----------
 1 file changed, 3 insertions(+), 10 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2-vision-mezzanine.dtso b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2-vision-mezzanine.dtso
index b9e4a5214f70..aceafea45343 100644
--- a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2-vision-mezzanine.dtso
+++ b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2-vision-mezzanine.dtso
@@ -51,8 +51,8 @@ camera@1a {
 
 		reset-gpios = <&tlmm 78 GPIO_ACTIVE_LOW>;
 		pinctrl-names = "default", "suspend";
-		pinctrl-0 = <&cam2_default>;
-		pinctrl-1 = <&cam2_suspend>;
+		pinctrl-0 = <&cam_mclk3_default>;
+		pinctrl-1 = <&cam_mclk3_suspend>;
 
 		clocks = <&camcc CAM_CC_MCLK3_CLK>;
 		assigned-clocks = <&camcc CAM_CC_MCLK3_CLK>;
@@ -73,14 +73,7 @@ imx577_ep: endpoint {
 };
 
 &tlmm {
-	cam2_default: cam2-default-state {
-		pins = "gpio67";
-		function = "cam_mclk";
-		drive-strength = <2>;
-		bias-disable;
-	};
-
-	cam2_suspend: cam2-suspend-state {
+	cam_mclk3_suspend: cam-mclk3-suspend-state {
 		pins = "gpio67";
 		function = "cam_mclk";
 		drive-strength = <2>;

-- 
2.55.0