[PATCH RESEND v9 3/9] media: qcom: camss: csiphy-3ph: Use odd bits for configuring C-PHY lanes

David Heidelberg via B4 Relay <[email protected]> Wed, 29 Jul 2026 22:19:58 +0200
Newsgroups org.kernel.vger.phone-devel,org.kernel.feeds.b4-sent,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-kernel,org.kernel.vger.linux-media
Message-ID <[email protected]>
From: David Heidelberg <[email protected]>

So far, only D-PHY mode was supported, which uses even bits when enabling
or masking lanes. For C-PHY configuration, the hardware instead requires
using the odd bits.

Since there can be unrecognized configuration allow returning failure.

Acked-by: Cory Keitz <[email protected]>
Reviewed-by: Bryan O'Donoghue <[email protected]>
Signed-off-by: David Heidelberg <[email protected]>
---
 .../platform/qcom/camss/camss-csiphy-3ph-1-0.c     | 25 ++++++++++++++--------
 1 file changed, 16 insertions(+), 9 deletions(-)

diff --git a/drivers/media/platform/qcom/camss/camss-csiphy-3ph-1-0.c b/drivers/media/platform/qcom/camss/camss-csiphy-3ph-1-0.c
index 7c8c0e41bc62f..dfcd9ed2eb7a3 100644
--- a/drivers/media/platform/qcom/camss/camss-csiphy-3ph-1-0.c
+++ b/drivers/media/platform/qcom/camss/camss-csiphy-3ph-1-0.c
@@ -9,16 +9,17 @@
  */
 
 #include "camss.h"
 #include "camss-csiphy.h"
 
 #include <linux/delay.h>
 #include <linux/interrupt.h>
 #include <linux/io.h>
+#include <linux/media-bus-format.h>
 
 #define CSIPHY_3PH_LNn_CFG1(n)			(0x000 + 0x100 * (n))
 #define CSIPHY_3PH_LNn_CFG1_SWI_REC_DLY_PRG	(BIT(7) | BIT(6))
 #define CSIPHY_3PH_LNn_CFG2(n)			(0x004 + 0x100 * (n))
 #define CSIPHY_3PH_LNn_CFG2_LP_REC_EN_INT	BIT(3)
 #define CSIPHY_3PH_LNn_CFG3(n)			(0x008 + 0x100 * (n))
 #define CSIPHY_3PH_LNn_CFG4(n)			(0x00c + 0x100 * (n))
 #define CSIPHY_3PH_LNn_CFG4_T_HS_CLK_MISS	0xa4
@@ -1108,23 +1109,32 @@ static void csiphy_gen2_config_lanes(struct csiphy_device *csiphy,
 		writel_relaxed(val, csiphy->base + r->reg_addr);
 		if (r->delay_us)
 			udelay(r->delay_us);
 	}
 }
 
 static u8 csiphy_get_lane_mask(struct csiphy_lanes_cfg *lane_cfg)
 {
-	u8 lane_mask;
-	int i;
+	u8 lane_mask = 0;
+	u8 offset = 0;
 
-	lane_mask = CSIPHY_3PH_CMN_CSI_COMMON_CTRL5_CLK_ENABLE;
+	switch (lane_cfg->phy_cfg) {
+	case V4L2_MBUS_CSI2_CPHY:
+		offset = 1;
+		break;
+	case V4L2_MBUS_CSI2_DPHY:
+		lane_mask = CSIPHY_3PH_CMN_CSI_COMMON_CTRL5_CLK_ENABLE;
+		break;
+	default:
+		break;
+	}
 
-	for (i = 0; i < lane_cfg->num_data; i++)
-		lane_mask |= BIT(lane_cfg->data[i].pos * 2);
+	for (int i = 0; i < lane_cfg->num_data; i++)
+		lane_mask |= BIT((lane_cfg->data[i].pos * 2) + offset);
 
 	return lane_mask;
 }
 
 static bool csiphy_is_gen2(u32 version)
 {
 	bool ret = false;
 
@@ -1155,20 +1165,17 @@ static void csiphy_lanes_enable(struct csiphy_device *csiphy,
 	struct csiphy_lanes_cfg *c = &cfg->csi2->lane_cfg;
 	struct csiphy_device_regs *regs = csiphy->regs;
 	u8 settle_cnt;
 	u8 val;
 	int i;
 
 	settle_cnt = csiphy_settle_cnt_calc(link_freq, csiphy->timer_clk_rate);
 
-	val = CSIPHY_3PH_CMN_CSI_COMMON_CTRL5_CLK_ENABLE;
-	for (i = 0; i < c->num_data; i++)
-		val |= BIT(c->data[i].pos * 2);
-
+	val = csiphy_get_lane_mask(c);
 	writel_relaxed(val, csiphy->base +
 		       CSIPHY_3PH_CMN_CSI_COMMON_CTRLn(regs->offset, 5));
 
 	val = CSIPHY_3PH_CMN_CSI_COMMON_CTRL6_COMMON_PWRDN_B;
 	writel_relaxed(val, csiphy->base +
 		       CSIPHY_3PH_CMN_CSI_COMMON_CTRLn(regs->offset, 6));
 
 	val = 0x02;

-- 
2.53.0