[PATCH RESEND v9 9/9] media: qcom: camss: Enable C-PHY where available

From: David Heidelberg <[email protected]>

After all the changes done we can now safely enable C-PHY for a SoC
where it's available.

Acked-by: Cory Keitz <[email protected]>
Reviewed-by: Bryan O'Donoghue <[email protected]>
Reviewed-by: Frank Li <[email protected]>
Signed-off-by: David Heidelberg <[email protected]>
---
 drivers/media/platform/qcom/camss/camss.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/media/platform/qcom/camss/camss.c b/drivers/media/platform/qcom/camss/camss.c
index 66171069057f8..ebf8f21b5fa2e 100644
--- a/drivers/media/platform/qcom/camss/camss.c
+++ b/drivers/media/platform/qcom/camss/camss.c
@@ -4760,21 +4760,21 @@ static int camss_parse_endpoint_node(struct device *dev,
 	struct v4l2_fwnode_endpoint vep = { { 0 } };
 	unsigned int i;
 	int ret;
 
 	ret = v4l2_fwnode_endpoint_parse(ep, &vep);
 	if (ret)
 		return ret;
 
-	/*
-	 * Most SoCs support both D-PHY and C-PHY standards, but currently only
-	 * D-PHY is supported in the driver.
-	 */
-	if (vep.bus_type != V4L2_MBUS_CSI2_DPHY) {
+	switch (vep.bus_type) {
+	case V4L2_MBUS_CSI2_CPHY:
+	case V4L2_MBUS_CSI2_DPHY:
+		break;
+	default:
 		dev_err(dev, "Unsupported bus type %d\n", vep.bus_type);
 		return -EINVAL;
 	}
 
 	csd->interface.csiphy_id = vep.base.port;
 
 	mipi_csi2 = &vep.bus.mipi_csi2;
 	lncfg->num_data = mipi_csi2->num_data_lanes;

-- 
2.53.0