Re: [PATCH v2 2/2] arm64: dts: qcom: sdm845-shift-axolotl: Add actuator for main rear camera

On 7/30/26 12:20 AM, David Heidelberg via B4 Relay wrote:
> From: David Heidelberg <[email protected]>
> 
> Main rear camera uses Dongwoon DW9714V actuator. Add regulator and
> actuator node.
> 
> Signed-off-by: David Heidelberg <[email protected]>
> ---

[...]

> +	/* SGM2036-2.8YUDH4G/TR */
> +	cam_bus_2p8: regulator-cam-bus-2p8 {
> +		compatible = "regulator-fixed";
> +
> +		regulator-name = "cam_bus_2p8";
> +		regulator-min-microvolt = <2800000>;
> +		regulator-max-microvolt = <2800000>;
> +		regulator-enable-ramp-delay = <100>;
> +
> +		gpio = <&tlmm 8 GPIO_ACTIVE_HIGH>;
> +		enable-active-high;
> +
> +		pinctrl-0 = <&cam_bus_avdd_default_state>;
> +		pinctrl-1 = <&cam_bus_avdd_sleep_state>;
> +		pinctrl-names = "default", "sleep";
> +
> +		vin-supply = <&vreg_bob>;
> +
> +		/*
> +		 * TODO: This node represent bus supply to the cam i2c module.
> +		 * Others DT do in similar fashion, but should be addressed
> +		 * by the bus-supply in the future
> +		 */

I can't quite parse the second sentence..

[...]

> +&cci_i2c0 {
> +	rear_camera_actuator: actuator@c {
> +		compatible = "dongwoon,dw9714v", "dongwoon,dw9714a", "dongwoon,dw9714";

1 a line would be neater

[...]

> +	cam_bus_avdd_default_state: cam-bus-avdd-default-state {
> +		pins = "gpio8";
> +		function = "gpio";
> +		bias-disable;
> +		drive-strength = <2>;

Other nodes have drive-strength first, then bias

> +	};
> +
> +	cam_bus_avdd_sleep_state: cam-bus-avdd-sleep-state {
> +		pins = "gpio8";
> +		function = "gpio";
> +		bias-disable;
> +		drive-strength = <2>;
> +		output-low;

Drop output-low, the regulator driver will set that

Konrad