[PATCH 1/8] dt-bindings: embedded-controller: qcom,hamoa-crd-ec: Add qcom,tsens

Add the qcom,tsens property so Hamoa-based boards can list the tsens
providers, and how many leading sensor IDs on each, whose readings the
driver averages to compute the SoC junction temperature reported to
the EC for fan control.

The generic thermal-sensors property has no standard semantic for
selecting a range of sensor IDs from a provider without enumerating
each one, so a vendor-specific phandle-array with an explicit sensor
count is used instead.

Signed-off-by: Anvesh Jain P <[email protected]>
---
 .../embedded-controller/qcom,hamoa-crd-ec.yaml     | 31 ++++++++++++++++++++++
 1 file changed, 31 insertions(+)

diff --git a/Documentation/devicetree/bindings/embedded-controller/qcom,hamoa-crd-ec.yaml b/Documentation/devicetree/bindings/embedded-controller/qcom,hamoa-crd-ec.yaml
index c07483aa5937..ec809fcd03ab 100644
--- a/Documentation/devicetree/bindings/embedded-controller/qcom,hamoa-crd-ec.yaml
+++ b/Documentation/devicetree/bindings/embedded-controller/qcom,hamoa-crd-ec.yaml
@@ -33,11 +33,40 @@ properties:
   interrupts:
     maxItems: 1
 
+  # A generic "thermal-sensors" phandle only identifies individual sensor
+  # IDs, and thermal zones are a Linux-side grouping of those sensors, not
+  # a devicetree concept the EC cares about. What the driver actually needs
+  # is raw readings from a contiguous range of leading sensor IDs on each
+  # tsens provider, averaged together, so qcom,tsens pairs each provider
+  # phandle with a count instead of enumerating every sensor cell.
+  qcom,tsens:
+    description:
+      List of tsens providers and, for each, the number of leading sensor
+      IDs on that provider whose readings are averaged to compute the SoC
+      junction temperature reported to the EC for fan control. Only
+      applicable for Hamoa based devices.
+    $ref: /schemas/types.yaml#/definitions/phandle-array
+    minItems: 1
+    maxItems: 2
+    items:
+      items:
+        - description: phandle to a tsens thermal-sensor provider
+        - description: number of leading sensor IDs on that provider to average
+
 required:
   - compatible
   - reg
   - interrupts
 
+if:
+  properties:
+    compatible:
+      contains:
+        const: qcom,glymur-crd-ec
+then:
+  properties:
+    qcom,tsens: false
+
 additionalProperties: false
 
 examples:
@@ -52,6 +81,8 @@ examples:
             reg = <0x76>;
 
             interrupts-extended = <&tlmm 66 IRQ_TYPE_LEVEL_HIGH>;
+
+            qcom,tsens = <&tsens3 2>;
         };
     };
 ...

-- 
2.34.1