Re: [PATCH v2] platform/x86: int3472: support the POWER1 GPIO type

Hi Jakob,

On Wed, Jul 29, 2026 at 01:03:46PM +0200, Jakob Berg Jespersen wrote:
> INT3472 can describe a second sensor power rail as a GPIO of type
> POWER1 (0x08), which the driver does not recognise, so the rail is left
> unmapped and never enabled:
> 
>   int3472-discrete INT3472:01: GPIO type 0x08 unknown; the sensor may
>   not work
> 
> On the Microsoft Surface Pro 7+ the rear camera's INT3472 (INT347A,
> ov8865) has such a pin; without it the ov8865 "dvdd" supply resolves to
> a dummy regulator and the sensor never probes.
> 
> Define the POWER0 (0x07) and POWER1 (0x08) GPIO types and map POWER1 to
> a regulator with con_id "dvdd" for all devices, the supply the in-tree
> ov8865 driver already requests. POWER0 is defined but left unmapped, as
> no device that uses it is known.
> 
> Out-of-tree work approached the same rail by exposing it to the sensor
> as a new "pwr1" supply (linux-surface PR #1867 for the Surface Pro 9,
> PR #2201 for the Pro 7+ ov8865); mapping POWER1 to the existing "dvdd"
> keeps the change contained to int3472.
> 
> With this change the Surface Pro 7+ rear camera probes and streams
> reliably.
> 
> Link: https://github.com/linux-surface/linux-surface/pull/1867
> Link: https://github.com/linux-surface/linux-surface/pull/2201
> Suggested-by: Sakari Ailus <[email protected]>
> Signed-off-by: Jakob Berg Jespersen <[email protected]>

Could you resend v2 (or v3, if there are changes) this and cc linux-media
list as well? (The MAINTAINERS change adding that list isn't merged yet.)

-- 
Regards,

Sakari Ailus