Re: [PATCH v4 0/5] Rate limited printing for Rust

On Mon, Aug 03, 2026 at 08:24:16AM +0200, Greg Kroah-Hartman wrote:
> On Mon, Aug 03, 2026 at 06:56:50AM +0200, Miguel Ojeda wrote:
> > On Fri, Jul 31, 2026 at 2:20 PM Alice Ryhl <[email protected]> wrote:
> > >
> > > It's not too long until the next cycle so going via Rust tree is ok with me.
> > >
> > > I'd appreciate if at least the first three could go together so we
> > > don't have split it over three release cycles, though.
> > 
> > Ok, Boqun: I think you didn't pick the first two for your tip PR,
> > shall I or Greg do it then?

Yeah.. I didn't find the time to pick these up, sorry about that.

> > 
> > Greg: should I pick all this through Rust, i.e. including Binder's, or
> > leave the Binder ones out, or do you want to pick them all?
> 
> I'd love to just take them all at once if no one objects, as odds are
> there are going to be binder merge conflicts due to the printk() changes
> in that codebase in the char-misc-next tree.
> 

Thanks a lot!

Regards,
Boqun

> thanks,
> 
> greg k-h