[PATCH] sparc: remove unused SERIAL_CONSOLE config option

There are no references to this option in SPARC or
architecture-independent code. Remove it to simplify the configuration
process.

Signed-off-by: Ethan Nelson-Moore <[email protected]>
---
 arch/sparc/Kconfig | 24 ------------------------
 1 file changed, 24 deletions(-)

diff --git a/arch/sparc/Kconfig b/arch/sparc/Kconfig
index a6b787efc2c4..fb53b21a8696 100644
--- a/arch/sparc/Kconfig
+++ b/arch/sparc/Kconfig
@@ -327,30 +327,6 @@ config SPARC_LED
 	  by reading /proc/led and its blinking mode can be changed
 	  via writes to /proc/led
 
-config SERIAL_CONSOLE
-	bool
-	depends on SPARC32
-	default y
-	help
-	  If you say Y here, it will be possible to use a serial port as the
-	  system console (the system console is the device which receives all
-	  kernel messages and warnings and which allows logins in single user
-	  mode). This could be useful if some terminal or printer is connected
-	  to that serial port.
-
-	  Even if you say Y here, the currently visible virtual console
-	  (/dev/tty0) will still be used as the system console by default, but
-	  you can alter that using a kernel command line option such as
-	  "console=ttyS1". (Try "man bootparam" or see the documentation of
-	  your boot loader (silo) about how to pass options to the kernel at
-	  boot time.)
-
-	  If you don't have a graphics card installed and you say Y here, the
-	  kernel will automatically use the first serial line, /dev/ttyS0, as
-	  system console.
-
-	  If unsure, say N.
-
 config SPARC_LEON
 	bool "Sparc Leon processor family"
 	depends on SPARC32
-- 
2.43.0