[PATCH v2 1/3] sparc32: honour phys_base in the viking cache flush routines

viking_flush_page() and viking_mxcc_flush_page() derive the physical
address of the page they are asked to flush by subtracting PAGE_OFFSET
from the kernel virtual address:

	sethi	%hi(PAGE_OFFSET), %g2
	sub	%o0, %g2, %g3

That is only the physical address when phys_base is zero. The C side spells
the same conversion __pa(), which adds phys_base, and every caller passes a
kernel virtual address expecting exactly that.

With a kernel loaded away from the start of RAM the two disagree by
phys_base. viking_flush_page() then compares cache tags against the wrong
page and flushes nothing, and viking_mxcc_flush_page() streams a page that
is phys_base lower than the one it was given, so the intended lines stay
dirty in the cache while unrelated ones are pushed out.

The visible effect is that anything relying on a flush to make memory
visible to another bus master silently keeps working from stale data. On a
SPARCstation 20 this shows up as every SCSI transfer failing with a DMA
error: iommu_flush_iotlb() cannot get the IOPTEs out to RAM, so the IOMMU
walks stale entries and the ESP DMA faults.

Add phys_base, so these agree with __pa() again. No change when phys_base
is zero, which is why this went unnoticed.

Signed-off-by: Magnus Lindholm <[email protected]>
Reviewed-by: Sam Ravnborg <[email protected]>
---
 arch/sparc/mm/viking.S | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/arch/sparc/mm/viking.S b/arch/sparc/mm/viking.S
index 48f062de7a7f..8b4e251bbba2 100644
--- a/arch/sparc/mm/viking.S
+++ b/arch/sparc/mm/viking.S
@@ -38,6 +38,9 @@ sun4dsmp_flush_tlb_spin:
 viking_flush_page:
 	sethi	%hi(PAGE_OFFSET), %g2
 	sub	%o0, %g2, %g3
+	sethi	%hi(phys_base), %g2
+	ld	[%g2 + %lo(phys_base)], %g2
+	add	%g3, %g2, %g3		! + phys_base = physical address
 	srl	%g3, 12, %g1		! ppage >> 12
 
 	clr	%o1			! set counter, 0 - 127
@@ -91,6 +94,9 @@ viking_flush_page:
 viking_mxcc_flush_page:
 	sethi	%hi(PAGE_OFFSET), %g2
 	sub	%o0, %g2, %g3
+	sethi	%hi(phys_base), %g2
+	ld	[%g2 + %lo(phys_base)], %g2
+	add	%g3, %g2, %g3			! + phys_base = physical address
 	sub	%g3, -PAGE_SIZE, %g3		! ppage + PAGE_SIZE
 	sethi	%hi(MXCC_SRCSTREAM), %o3	! assume %hi(MXCC_SRCSTREAM) == %hi(MXCC_DESTSTREAM)
 	mov	0x10, %g2			! set cacheable bit
-- 
2.43.0