[PATCH 5.10.y 4/5] serial: sc16is7xx: fix regression with GPIO configuration

From: Hugo Villeneuve <[email protected]>

[ Upstream commit 0499942928341d572a42199580433c2b0725211e ]

Commit 679875d1d880 ("sc16is7xx: Separate GPIOs from modem control lines")
and commit 21144bab4f11 ("sc16is7xx: Handle modem status lines")
changed the function of the GPIOs pins to act as modem control
lines without any possibility of selecting GPIO function.

As a consequence, applications that depends on GPIO lines configured
by default as GPIO pins no longer work as expected.

Also, the change to select modem control lines function was done only
for channel A of dual UART variants (752/762). This was not documented
in the log message.

Allow to specify GPIO or modem control line function in the device
tree, and for each of the ports (A or B).

Do so by using the new device-tree property named
"nxp,modem-control-line-ports" (property added in separate patch).

When registering GPIO chip controller, mask-out GPIO pins declared as
modem control lines according to this new DT property.

Fixes: 679875d1d880 ("sc16is7xx: Separate GPIOs from modem control lines")
Fixes: 21144bab4f11 ("sc16is7xx: Handle modem status lines")
Cc: [email protected]
Signed-off-by: Hugo Villeneuve <[email protected]>
Reviewed-by: Andy Shevchenko <[email protected]>
Reviewed-by: Lech Perczak <[email protected]>
Tested-by: Lech Perczak <[email protected]>
Acked-by: Rob Herring <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Greg Kroah-Hartman <[email protected]>
Stable-dep-of: af071d9e07e5 ("serial: sc16is7xx: implement gpio get_direction() callback")
Signed-off-by: Sasha Levin <[email protected]>
---
 drivers/tty/serial/sc16is7xx.c | 124 ++++++++++++++++++++++++++++-----
 1 file changed, 105 insertions(+), 19 deletions(-)

diff --git a/drivers/tty/serial/sc16is7xx.c b/drivers/tty/serial/sc16is7xx.c
index 236388776430c..e94006fd6e63b 100644
--- a/drivers/tty/serial/sc16is7xx.c
+++ b/drivers/tty/serial/sc16is7xx.c
@@ -237,7 +237,8 @@
 
 /* IOControl register bits (Only 750/760) */
 #define SC16IS7XX_IOCONTROL_LATCH_BIT	(1 << 0) /* Enable input latching */
-#define SC16IS7XX_IOCONTROL_MODEM_BIT	(1 << 1) /* Enable GPIO[7:4] as modem pins */
+#define SC16IS7XX_IOCONTROL_MODEM_A_BIT	(1 << 1) /* Enable GPIO[7:4] as modem A pins */
+#define SC16IS7XX_IOCONTROL_MODEM_B_BIT	(1 << 2) /* Enable GPIO[3:0] as modem B pins */
 #define SC16IS7XX_IOCONTROL_SRESET_BIT	(1 << 3) /* Software Reset */
 
 /* EFCR register bits */
@@ -294,6 +295,7 @@
 /* Misc definitions */
 #define SC16IS7XX_FIFO_SIZE		(64)
 #define SC16IS7XX_REG_SHIFT		2
+#define SC16IS7XX_GPIOS_PER_BANK	4
 
 struct sc16is7xx_devtype {
 	char	name[10];
@@ -326,7 +328,9 @@ struct sc16is7xx_port {
 	struct clk			*clk;
 #ifdef CONFIG_GPIOLIB
 	struct gpio_chip		gpio;
+	unsigned long			gpio_valid_mask;
 #endif
+	u8				mctrl_mask;
 	unsigned char			buf[SC16IS7XX_FIFO_SIZE];
 	struct kthread_worker		kworker;
 	struct task_struct		*kworker_task;
@@ -1237,8 +1241,98 @@ static int sc16is7xx_gpio_direction_output(struct gpio_chip *chip,
 
 	return 0;
 }
+
+static int sc16is7xx_gpio_init_valid_mask(struct gpio_chip *chip,
+					  unsigned long *valid_mask,
+					  unsigned int ngpios)
+{
+	struct sc16is7xx_port *s = gpiochip_get_data(chip);
+
+	*valid_mask = s->gpio_valid_mask;
+
+	return 0;
+}
+
+static int sc16is7xx_setup_gpio_chip(struct sc16is7xx_port *s)
+{
+	struct device *dev = s->p[0].port.dev;
+
+	if (!s->devtype->nr_gpio)
+		return 0;
+
+	switch (s->mctrl_mask) {
+	case 0:
+		s->gpio_valid_mask = GENMASK(7, 0);
+		break;
+	case SC16IS7XX_IOCONTROL_MODEM_A_BIT:
+		s->gpio_valid_mask = GENMASK(3, 0);
+		break;
+	case SC16IS7XX_IOCONTROL_MODEM_B_BIT:
+		s->gpio_valid_mask = GENMASK(7, 4);
+		break;
+	default:
+		break;
+	}
+
+	if (s->gpio_valid_mask == 0)
+		return 0;
+
+	s->gpio.owner		 = THIS_MODULE;
+	s->gpio.parent		 = dev;
+	s->gpio.label		 = dev_name(dev);
+	s->gpio.init_valid_mask	 = sc16is7xx_gpio_init_valid_mask;
+	s->gpio.direction_input	 = sc16is7xx_gpio_direction_input;
+	s->gpio.get		 = sc16is7xx_gpio_get;
+	s->gpio.direction_output = sc16is7xx_gpio_direction_output;
+	s->gpio.set		 = sc16is7xx_gpio_set;
+	s->gpio.base		 = -1;
+	s->gpio.ngpio		 = s->devtype->nr_gpio;
+	s->gpio.can_sleep	 = 1;
+
+	return gpiochip_add_data(&s->gpio, s);
+}
 #endif
 
+/*
+ * Configure ports designated to operate as modem control lines.
+ */
+static int sc16is7xx_setup_mctrl_ports(struct sc16is7xx_port *s)
+{
+	int i;
+	int ret;
+	int count;
+	u32 mctrl_port[2];
+	struct device *dev = s->p[0].port.dev;
+
+	count = device_property_count_u32(dev, "nxp,modem-control-line-ports");
+	if (count < 0 || count > ARRAY_SIZE(mctrl_port))
+		return 0;
+
+	ret = device_property_read_u32_array(dev, "nxp,modem-control-line-ports",
+					     mctrl_port, count);
+	if (ret)
+		return ret;
+
+	s->mctrl_mask = 0;
+
+	for (i = 0; i < count; i++) {
+		/* Use GPIO lines as modem control lines */
+		if (mctrl_port[i] == 0)
+			s->mctrl_mask |= SC16IS7XX_IOCONTROL_MODEM_A_BIT;
+		else if (mctrl_port[i] == 1)
+			s->mctrl_mask |= SC16IS7XX_IOCONTROL_MODEM_B_BIT;
+	}
+
+	if (s->mctrl_mask)
+		regmap_update_bits(
+			s->regmap,
+			SC16IS7XX_IOCONTROL_REG << SC16IS7XX_REG_SHIFT,
+			SC16IS7XX_IOCONTROL_MODEM_A_BIT |
+			SC16IS7XX_IOCONTROL_MODEM_B_BIT, s->mctrl_mask);
+
+	return 0;
+}
+
 static const struct serial_rs485 sc16is7xx_rs485_supported = {
 	.flags = SER_RS485_ENABLED | SER_RS485_RTS_AFTER_SEND,
 	.delay_rts_before_send = 1,
@@ -1346,6 +1440,7 @@ static int sc16is7xx_probe(struct device *dev,
 		sc16is7xx_port_write(&s->p[i].port, SC16IS7XX_EFCR_REG,
 				     SC16IS7XX_EFCR_RXDISABLE_BIT |
 				     SC16IS7XX_EFCR_TXDISABLE_BIT);
+
 		/* Initialize kthread work structs */
 		kthread_init_work(&s->p[i].tx_work, sc16is7xx_tx_proc);
 		kthread_init_work(&s->p[i].reg_work, sc16is7xx_reg_proc);
@@ -1382,23 +1477,14 @@ static int sc16is7xx_probe(struct device *dev,
 				s->p[u].irda_mode = true;
 	}
 
+	ret = sc16is7xx_setup_mctrl_ports(s);
+	if (ret)
+		goto out_ports;
+
 #ifdef CONFIG_GPIOLIB
-	if (devtype->nr_gpio) {
-		/* Setup GPIO cotroller */
-		s->gpio.owner		 = THIS_MODULE;
-		s->gpio.parent		 = dev;
-		s->gpio.label		 = dev_name(dev);
-		s->gpio.direction_input	 = sc16is7xx_gpio_direction_input;
-		s->gpio.get		 = sc16is7xx_gpio_get;
-		s->gpio.direction_output = sc16is7xx_gpio_direction_output;
-		s->gpio.set		 = sc16is7xx_gpio_set;
-		s->gpio.base		 = -1;
-		s->gpio.ngpio		 = devtype->nr_gpio;
-		s->gpio.can_sleep	 = 1;
-		ret = gpiochip_add_data(&s->gpio, s);
-		if (ret)
-			goto out_ports;
-	}
+	ret = sc16is7xx_setup_gpio_chip(s);
+	if (ret)
+		goto out_ports;
 #endif
 
 	/*
@@ -1421,7 +1507,7 @@ static int sc16is7xx_probe(struct device *dev,
 		return 0;
 
 #ifdef CONFIG_GPIOLIB
-	if (devtype->nr_gpio)
+	if (s->gpio_valid_mask)
 		gpiochip_remove(&s->gpio);
 #endif
 
@@ -1446,7 +1532,7 @@ static int sc16is7xx_remove(struct device *dev)
 	int i;
 
 #ifdef CONFIG_GPIOLIB
-	if (s->devtype->nr_gpio)
+	if (s->gpio_valid_mask)
 		gpiochip_remove(&s->gpio);
 #endif
 
-- 
2.53.0