[PATCH] i2c: mv64xxx: fix autosuspend cleanup

mv64xxx_i2c_probe() calls pm_runtime_use_autosuspend(), but the probe
failure and remove paths do not call the matching
pm_runtime_dont_use_autosuspend() before disabling runtime PM.

If the autosuspend delay is set to a negative value while autosuspend
is enabled, the runtime PM core increments usage_count to prevent
runtime suspend. Without undoing the autosuspend setting during
teardown, this reference is not dropped and usage_count remains
unbalanced.

Call pm_runtime_dont_use_autosuspend() in both the probe failure and
remove paths before disabling runtime PM to properly undo the
autosuspend setting.

This issue was found by manual code inspection.

Fixes: e5c02cf54154 ("i2c: mv64xxx: Add runtime PM support")
Cc: [email protected]
Signed-off-by: Guangshuo Li <[email protected]>
---
 drivers/i2c/busses/i2c-mv64xxx.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/i2c/busses/i2c-mv64xxx.c b/drivers/i2c/busses/i2c-mv64xxx.c
index 1acba628e16c..995b0e9b7f53 100644
--- a/drivers/i2c/busses/i2c-mv64xxx.c
+++ b/drivers/i2c/busses/i2c-mv64xxx.c
@@ -1069,6 +1069,7 @@ mv64xxx_i2c_probe(struct platform_device *pd)
 exit_free_irq:
 	free_irq(drv_data->irq, drv_data);
 exit_disable_pm:
+	pm_runtime_dont_use_autosuspend(&pd->dev);
 	pm_runtime_disable(&pd->dev);
 	if (!pm_runtime_status_suspended(&pd->dev))
 		mv64xxx_i2c_runtime_suspend(&pd->dev);
@@ -1083,6 +1084,7 @@ mv64xxx_i2c_remove(struct platform_device *pd)
 
 	i2c_del_adapter(&drv_data->adapter);
 	free_irq(drv_data->irq, drv_data);
+	pm_runtime_dont_use_autosuspend(&pd->dev);
 	pm_runtime_disable(&pd->dev);
 	if (!pm_runtime_status_suspended(&pd->dev))
 		mv64xxx_i2c_runtime_suspend(&pd->dev);
-- 
2.43.0