[PATCH] doc/iscsi: typo fix in doc/README.iscsi
Zhang Yanfei <[email protected]>
| Newsgroups | org.kernel.vger.stgt |
|---|---|
| Message-ID | <[email protected]> |
From: Zhang Yanfei <[email protected]> Signed-off-by: Zhang Yanfei <[email protected]> --- doc/README.iscsi | 8 ++++---- 1 files changed, 4 insertions(+), 4 deletions(-) diff --git a/doc/README.iscsi b/doc/README.iscsi index 4ff3028..9fc21dd 100644 --- a/doc/README.iscsi +++ b/doc/README.iscsi @@ -25,7 +25,7 @@ The following example creates a target with id 1 (the iqn is iqn.2001-04.com.example:storage.disk2.amiens.sys1.xyz) and adds a logical unit (backed by /dev/hdc1) with lun 1. -Let's create one target devce. +Let's create one target device. host:~/tgt$ su host:~/tgt# ./usr/tgtadm --lld iscsi --op new --mode target --tid 1 -T iqn.2001-04.com.example:storage.disk2.amiens.sys1.xyz @@ -113,7 +113,7 @@ Note "ACL information" section. "ALL" means that this target accepts any initiators. The ACL feature also provides the access control based on initiators' addresses. -First, let's remove "ALL" options: +First, let's remove "ALL" option: host:~/tgt# ./usr/tgtadm --lld iscsi --op unbind --mode target --tid 1 -I ALL host:~/tgt# ./usr/tgtadm --lld iscsi --op show --mode target @@ -224,12 +224,12 @@ IFMarkInt=Reject MaxConnections=1 -You can chage iSCSI parameters like the folloing (e.g. set +You can change iSCSI parameters like the following (e.g. set MaxRecvDataSegmentLength to 16384): host:~/tgt# ./usr/tgtadm --lld iscsi --mode target --op update --tid 1 --name MaxRecvDataSegmentLength --value 16384 -You can get iSCSI parameters again to see it change: +You can get iSCSI parameters again to see its change: host:~/tgt# ./usr/tgtadm --lld iscsi --op show --mode target --tid 1 MaxRecvDataSegmentLength=16384 -- 1.7.1