Re: [PATCH v3] scsi: target: fix iSCSI ISID use-after-free in REGISTER AND MOVE

On 10/06/2026 05:22, Bryam Vargas wrote:
> core_scsi3_emulate_pro_register_and_move() maps the PERSISTENT RESERVE OUT
> parameter list with transport_kmap_data_sg() and parses the destination
> TransportID with target_parse_pr_out_transport_id(). For an iSCSI
> TransportID (FORMAT CODE 01b), iscsi_parse_pr_out_transport_id() returns
> the ISID in iport_ptr as a raw pointer into that mapped buffer.
> 
> The function then unmaps the buffer with transport_kunmap_data_sg() before
> dereferencing iport_ptr in strcmp(), __core_scsi3_locate_pr_reg() and
> core_scsi3_alloc_registration(). When the parameter list spans more than
> one page (PARAMETER LIST LENGTH > 4096), transport_kmap_data_sg() uses
> vmap() and transport_kunmap_data_sg() does vunmap(), so the kernel virtual
> address backing iport_ptr is torn down and every subsequent dereference is
> a use-after-free read of the unmapped region.
> 
> Keep the parameter list mapped until iport_ptr is no longer needed: drop
> the early transport_kunmap_data_sg() and unmap once on the success path,
> right before returning. The error paths already unmap through the existing
> "if (buf) transport_kunmap_data_sg(cmd)" at the out: label, which now runs
> on every post-map error exit because buf is no longer cleared early. Only
> reads of the mapping happen while spinlocks are held; the map and unmap
> calls remain outside any lock. The sibling caller
> core_scsi3_decode_spec_i_port() already uses the buffer before unmapping it
> and is left unchanged.
> 
> Fixes: 4949314c7283 ("target: Allow control CDBs with data > 1 page")
> Cc:[email protected]
> Signed-off-by: Bryam Vargas<[email protected]>

FWIW:
Reviewed-by: John Garry <[email protected]>