Re: AF_XDP busy poll receives packets in batches of 8 on i40e

Federico Parola <[email protected]> wrote:

>Hello everybody,
>I'm experiencing a strange problem when running an AF_XDP application with
>busy poll enabled on a Intel XL710 NIC (i40e driver).
>The problem can be replicated running the xdpsock kernel sample in rx or
>l2fwd mode.
>The first packet I send to the machine is correctly received by the
>application. After this, packets are only received in batches of 8.
>If I send 7 packets the application sees nothing, while the 8th one
>triggers the reception of all 8 packets.
>Disabling the busy poll mode everything works fine and packets are
>immediately received as they are sent.
>
>I tried changing kernel (5.12, 5.14 and 5.16) but all present the same
>problem.
>I also tried using another NIC, an Intel X540 with ixgbe driver and the
>problem isn't there, so I guess is NIC/driver related.
>
>I tried monitoring ethtool statistics. When sending packets between 1 and
>7 these counters are increased:
>stat:           64 (             64) <= port.rx_bytes /sec
>stat:            1 (              1) <= port.rx_size_64 /sec
>stat:            1 (              1) <= port.rx_unicast /sec
>stat:            1 (              1) <= rx_unicast /sec
>
>While the 8th one triggers this updates:
>stat:           64 (             64) <= port.rx_bytes /sec
>stat:            1 (              1) <= port.rx_size_64 /sec
>stat:            1 (              1) <= port.rx_unicast /sec
>stat:          477 (            477) <= rx-0.bytes /sec
>stat:            8 (              8) <= rx-0.packets /sec
>stat:          477 (            477) <= rx_bytes /sec
>stat:            8 (              8) <= rx_packets /sec
>stat:            1 (              1) <= rx_unicast /sec
>
>As far as I understand the first set of counters are hardware counters, so
>it makes me think that packets are kept in the NIC and not even sent to
>memory.
>
>Does anyone have any suggestion on what could be causing this problem?
>Does enabling busy poll set some flag on the NIC?

	We observed similar "batching" behavior on i40e devices late
last year in ordinary use (not XDP, but using SR-IOV VFs).  We
instrumented the drivers at the send and receive sides, and determined
that it appeared to be a behavior of the receiving device itself, i.e.,
packets 1 - 7 would be held indefinitely (as I recall, no interrupt or
update of the RX ring pointers) until packet 8 arrives, at which point
all 8 were delivered simultaneously.

	The issue was evidently in the firmware, and was resolved after
a firmware upgrade.

	-J

>
>Best regards,
>Federico Parola

---
	-Jay Vosburgh, [email protected]