Channel Flags question

Hi:

in the Lab I have a Ubiquity bullet that I have configured for Turbo and 
10/5Mhz bandwidth which is using the Atheros 9280.  I have modified the 
Atheros ath9k driver to go into all three bandwidths (Turbo, 10/5Mhz), 
but I am having a problem trying to have to display the correct bit 
settings when I monitor my 2 Ubiquity's that are in these modes. 
According to ieee80211_radiotap.h there is a setting for Turbo, but 
there is no channel flag for either the 10Mhz or 5Mhz bandwidth. What 
channel flags should I use for the 10 and 5Mhz bandwidth?

Thanks
Clyde