[PATCH 01/10] hw/arm: fsl-imx6ul: Add SCU compatibility window

U-Boot's common i.MX6 CPU identification code reads the Cortex-A9
SCU configuration register at PERIPHBASE + 0x4 even on i.MX6UL.
The value is only used to distinguish Cortex-A9 i.MX6 variants.

Cortex-A7 reserves this address and reading it causes data abort.

The same U-Boot abort was discussed on qemu-arm in September 2024:
https://lists.gnu.org/archive/html/qemu-arm/2024-09/msg00072.html

Map only the four-byte configuration-register address as an
unimplemented device. Its zero read result gives U-Boot the
single-CPU encoding after the low two bits are masked, while
the remainder of the reserved Cortex-A7 page stays unmapped.

Signed-off-by: Bin Meng <[email protected]>
---

 hw/arm/fsl-imx6ul.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/hw/arm/fsl-imx6ul.c b/hw/arm/fsl-imx6ul.c
index 1863558a0d..d6f662efe4 100644
--- a/hw/arm/fsl-imx6ul.c
+++ b/hw/arm/fsl-imx6ul.c
@@ -187,6 +187,15 @@ static void fsl_imx6ul_realize(DeviceState *dev, Error **errp)
     sysbus_realize(SYS_BUS_DEVICE(mpcore), &error_abort);
     sysbus_mmio_map(SYS_BUS_DEVICE(mpcore), 0, FSL_IMX6UL_A7MPCORE_ADDR);
 
+    /*
+     * U-Boot's shared i.MX6 CPU identification code reads the
+     * Cortex-A9 SCU configuration register on i.MX6UL. Cortex-A7
+     * reserves this address, so provide only the compatibility word
+     * needed before the console is initialized.
+     */
+    create_unimplemented_device("a7mpcore-scu-compat",
+                                FSL_IMX6UL_A7MPCORE_ADDR + 0x4, 4);
+
     gic = mpcore;
     gicsbd = SYS_BUS_DEVICE(gic);
     cpu = DEVICE(&s->cpu);
-- 
2.53.0