Re: [RFC v5 20/28] hw/arm/smmuv3: Route IRQ and GERROR handling by SEC_SID

On 8/13/2026 9:25 AM, Tao Tang wrote:
> Interrupt and global error handling currently always selects the
> Non-secure register bank, even when the event or command originates
> from the Secure programming interface. This splits CMDQ_CONS.ERR from
> GERROR.CMDQ_ERR and prevents Secure software from acknowledging the
> error through S_GERRORN.
> 
> Pass SEC_SID through the IRQ and GERROR helpers and all queue call
> sites so interrupt enable checks, global error reporting, and
> acknowledgement use the originating programming-interface bank.
> 
> Signed-off-by: Tao Tang <[email protected]>
> ---
>  hw/arm/smmuv3.c | 20 +++++++++++---------
>  1 file changed, 11 insertions(+), 9 deletions(-)
> 

Reviewed-by: Pierrick Bouvier <[email protected]>