Re: [Intel-wired-lan] [PATCH bpf-next v5 8/8] selftests: net: add test for XDP_PASS skb checksum invalidation

> On 07/16, Lorenzo Bianconi wrote:
> > On Jul 16, Stanislav Fomichev wrote:
> > > On 07/15, Lorenzo Bianconi wrote:
> > > > Add a test that verifies skb->ip_summed is set to CHECKSUM_NONE
> > > > when a device running in XDP mode creates an skb from a xdp_buff
> > > > if the attached ebpf program returns an XDP_PASS.
> > > > The test attaches an XDP program returning XDP_PASS, and a TC
> > > > ingress program that runs the bpf_skb_rx_checksum() kfunc to
> > > > inspect the resulting skb. After XDP_PASS the driver must invalidate
> > > > any previously computed hardware RX checksum since XDP may have
> > > > modified the packet data.
> > > > The BPF program counts packets per checksum type in a map, and the
> > > > test runner verifies that after sending traffic the CHECKSUM_NONE
> > > > counter is non-zero while CHECKSUM_UNNECESSARY and CHECKSUM_COMPLETE
> > > > counters are zero.
> > > > 
> > > > Signed-off-by: Lorenzo Bianconi <[email protected]>
> > > > ---
> > > >  Documentation/networking/xdp-rx-metadata.rst       |  5 ++
> > > >  .../selftests/drivers/net/hw/xdp_metadata.py       | 55 +++++++++++++++-
> > > >  .../selftests/net/lib/skb_metadata_csum.bpf.c      | 73 ++++++++++++++++++++++
> > > >  3 files changed, 132 insertions(+), 1 deletion(-)
> > > > 
> > > > diff --git a/Documentation/networking/xdp-rx-metadata.rst b/Documentation/networking/xdp-rx-metadata.rst
> > > > index 93918b3769a3..7434ac98242a 100644
> > > > --- a/Documentation/networking/xdp-rx-metadata.rst
> > > > +++ b/Documentation/networking/xdp-rx-metadata.rst
> > > > @@ -90,6 +90,11 @@ conversion, and the XDP metadata is not used by the kernel when building
> > > >  ``skbs``. However, TC-BPF programs can access the XDP metadata area using
> > > >  the ``data_meta`` pointer.
> > > 
> > > [..]
> > > 
> > > > +If a driver is running in XDP mode, any existing hardware RX checksum
> > > > +(``CHECKSUM_UNNECESSARY`` or ``CHECKSUM_COMPLETE``) must be invalidated
> > > > +by setting ``skb->ip_summed`` to ``CHECKSUM_NONE`` before passing the
> > > > +skb to the kernel, since XDP may have modified the packet data.
> > > > +
> > > >  In the future, we'd like to support a case where an XDP program
> > > >  can override some of the metadata used for building ``skbs``.
> > > 
> > > Sorry for keeping nitpicking on this, but I'm still not convinced that
> > > it is what we currently do. From my previous reply:
> > 
> > no worries :)
> > My current take-away from the previous discussion is we just need to document
> > what would be the driver expected behaviour adding a kselftest for it (without
> > modifying any driver).
> > 
> > > 
> > > > > Looking at a few drivers:
> > > > > - bnxt (bnxt_rx_pkt) does UNNECESSARY - ok
> > > > > - mlx5 (mlx5e_handle_csum) does UNNECESSARY and skips COMPLETE if there is
> > > > >   bpf prog attached
> > > > > - fbnic (fbnic_rx_csum) - can do COMPLETE even with xdp attached?
> > > > > - gve (gve_rx) - can do COMPLETE even with xdp attached?
> > > 
> > > (although for gve I might be wrong, there is also gve_rx_skb_csum that only
> > > does UNNECESSARY).
> > > 
> > > I'd wait for Jakub to chime in, but it feels like we should just document
> > > what we currently do as a recommended approach: for the drivers
> > > that support COMPLETE, do not report it when the bpf program is attached.
> > > Both NONE and UNNECESSARY are ok.
> > 
> > I am not completely sure the UNNECESSARY case is different from the COMPLETE
> > one. What are we supposed to do if the driver reports UNNECESSARY and the ebpf
> > program modifies some fields covered by the rx-checksum?
> 
> For unnecessary, I think the safe expectation is that the bpf program
> will update the value of the checksum in the packet if it touches the data?

I do not have a strong opinion on it.
@Jakub: any input on it?

> 
> > > Also, did you run this test on real HW? NIPA now has HW tests, maybe it
> > > makes sense to route this series via net-next to get the real coverage?
> > 
> > What about splitting this series and have two different series:
> > - bpf-next: add xdp rx kfunc and related selftest
> > - net-next: add kselftest for the driver expected behaviour.
> > 
> > What do you think?
> 
> I'd post everything to net-next to get the HW coverage. Once you get all
> the acks we can ask the maintainers' guidance.

ack, I am fine with that.

Regards,
Lorenzo

-----BEGIN PGP SIGNATURE-----

iHUEABYKAB0WIQTquNwa3Txd3rGGn7Y6cBh0uS2trAUCal6cdAAKCRA6cBh0uS2t
rBbAAQDuKu2WNBvm2CcO6No6R6S427G1mLi7hdfmjTMduKOLYwEA9/j6hFjjCn7s
9OGAW6D4Pk31PHVDpSIYW7xQEkUWTwU=
=j1RN
-----END PGP SIGNATURE-----