[PATCH 3/4] dt-bindings: ipmi: Add optional LPC properties to ASPEED BT devices

From: Yu-Che Hsieh <[email protected]>

Allocating IO and IRQ resources to LPC devices is in-theory an operation

for the host, however ASPEED systems describe these resources through

BMC-internal configuration, as already supported by the ASPEED KCS BMC

binding.

Add aspeed,lpc-io-reg and aspeed,lpc-interrupts to the ASPEED BT BMC

binding so firmware can describe the host LPC IO address and SerIRQ

configuration using the same properties as KCS devices.

Signed-off-by: Yu-Che Hsieh <[email protected]>
---
 .../bindings/ipmi/aspeed,ast2400-ibt-bmc.yaml       | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/Documentation/devicetree/bindings/ipmi/aspeed,ast2400-ibt-bmc.yaml b/Documentation/devicetree/bindings/ipmi/aspeed,ast2400-ibt-bmc.yaml
index c4f7cdbbe16b..1803c6bbae93 100644
--- a/Documentation/devicetree/bindings/ipmi/aspeed,ast2400-ibt-bmc.yaml
+++ b/Documentation/devicetree/bindings/ipmi/aspeed,ast2400-ibt-bmc.yaml
@@ -25,6 +25,24 @@ properties:
   interrupts:
     maxItems: 1
 
+  aspeed,lpc-io-reg:
+    $ref: /schemas/types.yaml#/definitions/uint32-array
+    maxItems: 1
+    description: |
+      The host CPU LPC IO address for the BT device.
+
+  aspeed,lpc-interrupts:
+    $ref: /schemas/types.yaml#/definitions/uint32-array
+    minItems: 2
+    maxItems: 2
+    description: |
+      A 2-cell property expressing the LPC SerIRQ number and the interrupt
+      level/sense encoding (specified in the standard fashion).
+
+      Note that the generated interrupt is issued from the BMC to the host, and
+      thus the target interrupt controller is not captured by the BMC's
+      devicetree.
+
 required:
   - compatible
   - reg
@@ -35,10 +53,13 @@ additionalProperties: false
 examples:
   - |
     #include <dt-bindings/clock/aspeed-clock.h>
+    #include <dt-bindings/interrupt-controller/irq.h>
 
     bt@1e789140 {
         compatible = "aspeed,ast2400-ibt-bmc";
         reg = <0x1e789140 0x18>;
         interrupts = <8>;
         clocks = <&syscon ASPEED_CLK_GATE_LCLK>;
+        aspeed,lpc-io-reg = <0xe4>;
+        aspeed,lpc-interrupts = <10 IRQ_TYPE_LEVEL_LOW>;
     };

-- 
2.34.1