[PATCH v3 02/17] spi: bcm63xx-hsspi: Use helper function devm_clk_get_enabled()

devm_clk_get() and clk_prepare_enable() can now be replaced by
devm_clk_get_enabled() when driver enables the clocks. Moreover, it is no
longer necessary to unprepare and disable the clocks explicitly.
Simplify code.

Signed-off-by: Pei Xiao <[email protected]>
---
 drivers/spi/spi-bcm63xx-hsspi.c | 46 +++++++++------------------------
 1 file changed, 12 insertions(+), 34 deletions(-)

diff --git a/drivers/spi/spi-bcm63xx-hsspi.c b/drivers/spi/spi-bcm63xx-hsspi.c
index 612f8802e690..266eabd3715b 100644
--- a/drivers/spi/spi-bcm63xx-hsspi.c
+++ b/drivers/spi/spi-bcm63xx-hsspi.c
@@ -758,8 +758,7 @@ static int bcm63xx_hsspi_probe(struct platform_device *pdev)
 	if (IS_ERR(regs))
 		return PTR_ERR(regs);
 
-	clk = devm_clk_get(dev, "hsspi");
-
+	clk = devm_clk_get_enabled(dev, "hsspi");
 	if (IS_ERR(clk))
 		return PTR_ERR(clk);
 
@@ -767,41 +766,26 @@ static int bcm63xx_hsspi_probe(struct platform_device *pdev)
 	if (IS_ERR(reset))
 		return PTR_ERR(reset);
 
-	ret = clk_prepare_enable(clk);
-	if (ret)
-		return ret;
-
 	ret = reset_control_reset(reset);
-	if (ret) {
-		dev_err(dev, "unable to reset device: %d\n", ret);
-		goto out_disable_clk;
-	}
+	if (ret)
+		return dev_err_probe(dev, ret, "unable to reset device: %d\n", ret);
 
 	rate = clk_get_rate(clk);
 	if (!rate) {
-		pll_clk = devm_clk_get(dev, "pll");
-
-		if (IS_ERR(pll_clk)) {
-			ret = PTR_ERR(pll_clk);
-			goto out_disable_clk;
-		}
-
-		ret = clk_prepare_enable(pll_clk);
-		if (ret)
-			goto out_disable_clk;
+		pll_clk = devm_clk_get_enabled(dev, "pll");
+		if (IS_ERR(pll_clk))
+			return dev_err_probe(dev, PTR_ERR(pll_clk),
+					     "failed enable pll clk\n");
 
 		rate = clk_get_rate(pll_clk);
-		if (!rate) {
-			ret = -EINVAL;
-			goto out_disable_pll_clk;
-		}
+		if (!rate)
+			return dev_err_probe(dev, -EINVAL,
+					     "failed get pll clk rate\n");
 	}
 
 	host = spi_alloc_host(&pdev->dev, sizeof(*bs));
-	if (!host) {
-		ret = -ENOMEM;
-		goto out_disable_pll_clk;
-	}
+	if (!host)
+		return dev_err_probe(dev, -ENOMEM, "alloc host no mem\n");
 
 	bs = spi_controller_get_devdata(host);
 	bs->pdev = pdev;
@@ -887,10 +871,6 @@ static int bcm63xx_hsspi_probe(struct platform_device *pdev)
 	pm_runtime_disable(&pdev->dev);
 out_put_host:
 	spi_controller_put(host);
-out_disable_pll_clk:
-	clk_disable_unprepare(pll_clk);
-out_disable_clk:
-	clk_disable_unprepare(clk);
 	return ret;
 }
 
@@ -902,8 +882,6 @@ static void bcm63xx_hsspi_remove(struct platform_device *pdev)
 
 	/* reset the hardware and block queue progress */
 	__raw_writel(0, bs->regs + HSSPI_INT_MASK_REG);
-	clk_disable_unprepare(bs->pll_clk);
-	clk_disable_unprepare(bs->clk);
 	sysfs_remove_group(&pdev->dev.kobj, &bcm63xx_hsspi_group);
 }
 
-- 
2.25.1