Re: [PATCH v5 2/3] dt-bindings: mfd: aspeed,ast2x00-scu: Describe AST2700 SCU0
Billy Tsai <[email protected]>
| Newsgroups | org.ozlabs.lists.openbmc,org.infradead.lists.linux-arm-kernel,org.kernel.vger.linux-clk,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-gpio,org.kernel.vger.linux-kernel,org.ozlabs.lists.linux-aspeed |
|---|---|
| Message-ID | <OSQPR06MB725204B2FAE543A71AEA52C38B51A@OSQPR06MB7252.apcprd06.prod.outlook.com> |
> > AST2700 consists of two interconnected SoC instances, each with its own > > System Control Unit (SCU). The SCU0 provides pin control, interrupt > > controllers, clocks, resets, and address-space mappings for the > > Secondary and Tertiary Service Processors (SSP and TSP). > > > > Describe the SSP/TSP address mappings using the standard > > memory-region and memory-region-names properties. > > > > Disallow legacy child nodes that are not present on AST2700, including > > p2a-control and smp-memram. The latter is unnecessary as software can > > access the scratch registers via the SCU syscon. > > > > Also allow the AST2700 SoC0 pin controller to be described as a child > > node of the SCU0, and add an example illustrating the SCU0 layout, > > including reserved-memory, interrupt controllers, and pinctrl. > > > > Signed-off-by: Billy Tsai <[email protected]> > > --- > > .../bindings/mfd/aspeed,ast2x00-scu.yaml | 117 +++++++++++++++++++++ > > 1 file changed, 117 insertions(+) > > > > diff --git a/Documentation/devicetree/bindings/mfd/aspeed,ast2x00-scu.yaml b/Documentation/devicetree/bindings/mfd/aspeed,ast2x00-scu.yaml > > index a87f31fce019..86d51389689c 100644 > > --- a/Documentation/devicetree/bindings/mfd/aspeed,ast2x00-scu.yaml > > +++ b/Documentation/devicetree/bindings/mfd/aspeed,ast2x00-scu.yaml > > @@ -46,6 +46,9 @@ properties: > > '#reset-cells': > > const: 1 > > > > + memory-region: true > > + memory-region-names: true > Missing constraints. From where did you take such syntax (so I can fix > it)? The intention was to constrain these properties conditionally for AST2700 SCU0 as done further down in the patch. I can update the binding so that memory-region and memory-region-names have baseline constraints (e.g. minItems and maxItems), and then refine them in the conditional branches for AST2700SCU0, AST2700SCU1 and others memory-region: minItems: 2 maxItems: 3 memory-region-names: minItems: 2 maxItems: 3 Best regards, Billy Tsai