Simultaneous Firmware update and get sensor reading failing

"K, Shiva Shankar" <[email protected]>
Newsgroups org.ozlabs.lists.openbmc
Message-ID <CY5PR11MB6137C593E2E9DA3BBAF5C24AAD072@CY5PR11MB6137.namprd11.prod.outlook.com> 
Hi Team,

I have been working on pldm firmware update and the pldm monitoring and control.

Problem:

I am performing AMC  firmware update  from bmc and then simultaneously requesting sensor data from AMC using GetSensorReading command. Both the commands get stuck at BMC's end and neither command is sent to AMC after that.


  1.
May I know whether we can pause get sensor reading?
  2.
What's the ideal time interval between two getsensorreading command?

And let me know if u any other suggestion to get rid of this issue.  It would be great to hear from the OpenBMC.

Regards,
Shiva Shankar K.
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.